Commit 826ed670 authored by Linus Walleij's avatar Linus Walleij

plat-nomadik: new sleep mode pincfg macros

This adds a few sleep mode pin config macros for sleep mode
for the Nomadik GPIO/pin controller.
Signed-off-by: default avatarRickard Andersson <rickard.andersson@stericsson.com>
Signed-off-by: default avatarRikard Olsson <rikard.p.olsson@stericsson.com>
Signed-off-by: default avatarJonas Aaberg <jonas.aberg@stericsson.com>
Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
parent 8d91771c
......@@ -24,6 +24,7 @@
* bit 16..18 - SLPM pull up/down state
* bit 19..20 - SLPM direction
* bit 21..22 - SLPM Value (if output)
* bit 23..25 - PDIS value (if input)
*
* to facilitate the definition, the following macros are provided
*
......@@ -67,6 +68,10 @@ typedef unsigned long pin_cfg_t;
/* These two replace the above in DB8500v2+ */
#define PIN_SLPM_WAKEUP_ENABLE (NMK_GPIO_SLPM_WAKEUP_ENABLE << PIN_SLPM_SHIFT)
#define PIN_SLPM_WAKEUP_DISABLE (NMK_GPIO_SLPM_WAKEUP_DISABLE << PIN_SLPM_SHIFT)
#define PIN_SLPM_USE_MUX_SETTINGS_IN_SLEEP PIN_SLPM_WAKEUP_DISABLE
#define PIN_SLPM_GPIO PIN_SLPM_WAKEUP_ENABLE /* In SLPM, pin is a gpio */
#define PIN_SLPM_ALTFUNC PIN_SLPM_WAKEUP_DISABLE /* In SLPM, pin is altfunc */
#define PIN_DIR_SHIFT 14
#define PIN_DIR_MASK (0x1 << PIN_DIR_SHIFT)
......@@ -105,6 +110,14 @@ typedef unsigned long pin_cfg_t;
#define PIN_SLPM_VAL_LOW ((1 + 0) << PIN_SLPM_VAL_SHIFT)
#define PIN_SLPM_VAL_HIGH ((1 + 1) << PIN_SLPM_VAL_SHIFT)
#define PIN_SLPM_PDIS_SHIFT 23
#define PIN_SLPM_PDIS_MASK (0x3 << PIN_SLPM_PDIS_SHIFT)
#define PIN_SLPM_PDIS(x) \
(((x) & PIN_SLPM_PDIS_MASK) >> PIN_SLPM_PDIS_SHIFT)
#define PIN_SLPM_PDIS_NO_CHANGE (0 << PIN_SLPM_PDIS_SHIFT)
#define PIN_SLPM_PDIS_DISABLED (1 << PIN_SLPM_PDIS_SHIFT)
#define PIN_SLPM_PDIS_ENABLED (2 << PIN_SLPM_PDIS_SHIFT)
#define PIN_LOWEMI_SHIFT 25
#define PIN_LOWEMI_MASK (0x1 << PIN_LOWEMI_SHIFT)
#define PIN_LOWEMI(x) (((x) & PIN_LOWEMI_MASK) >> PIN_LOWEMI_SHIFT)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment