ide: fix 40-wire cable detection for TSST SH-S202* ATAPI devices (v2)

Since 2.6.26 we support UDMA66 on ATAPI devices requiring IVB quirk:

  commit 8588a2b7
  ("ide: add SH-S202J to ivb_list[]")

We also later added support for more such devices in:

  commit e97564f3
  ("ide: More TSST drives with broken cable detection")

and in:

  commit 3ced5c49
  ("ide: add TSSTcorp CDDVDW SH-S202H to ivb_list[]")

It turns out that such devices lack cable detection altogether
(which in turn results in incorrect detection of 40-wire cables
by our current cable detection strategy) so always handle them
by trusting host-side cable detection only.

v2:
Model detection fixup from Martin.
Reported-and-tested-by: default avatarMartin Lottermoser <Martin.Lottermoser@t-online.de>
Signed-off-by: default avatarBartlomiej Zolnierkiewicz <bzolnier@gmail.com>
parent d8788298
......@@ -206,8 +206,6 @@ EXPORT_SYMBOL_GPL(ide_in_drive_list);
/*
* Early UDMA66 devices don't set bit14 to 1, only bit13 is valid.
* We list them here and depend on the device side cable detection for them.
*
* Some optical devices with the buggy firmwares have the same problem.
*/
static const struct drive_list_entry ivb_list[] = {
......@@ -251,10 +249,25 @@ u8 eighty_ninty_three(ide_drive_t *drive)
* - force bit13 (80c cable present) check also for !ivb devices
* (unless the slave device is pre-ATA3)
*/
if ((id[ATA_ID_HW_CONFIG] & 0x4000) ||
(ivb && (id[ATA_ID_HW_CONFIG] & 0x2000)))
if (id[ATA_ID_HW_CONFIG] & 0x4000)
return 1;
if (ivb) {
const char *model = (char *)&id[ATA_ID_PROD];
if (strstr(model, "TSSTcorp CDDVDW SH-S202")) {
/*
* These ATAPI devices always report 80c cable
* so we have to depend on the host in this case.
*/
if (hwif->cbl == ATA_CBL_PATA80)
return 1;
} else {
/* Depend on the device side cable detection. */
if (id[ATA_ID_HW_CONFIG] & 0x2000)
return 1;
}
}
no_80w:
if (drive->dev_flags & IDE_DFLAG_UDMA33_WARNED)
return 0;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment