Input: add support for HiDeep touchscreen

The HiDeep touchscreen device is a capacitive multi-touch controller
mainly for multi-touch supported devices use. It use I2C interface for
communication to IC and provide axis X, Y, Z locations for ten finger
touch through input event interface to userspace.

It support the Crimson and the Lime two type IC. They are different
the number of channel supported and FW size. But the working protocol
is same.
Signed-off-by: Anthony Kim <anthony.kim@hideep.com>
Acked-by: Rob Herring <robh+dt@kernel.org>
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>

Documentation/devicetree/bindings/input/touchscreen/hideep.txt

+* HiDeep Finger and Stylus touchscreen controller
+
+Required properties:
+- compatible		: must be "hideep,hideep-ts"
+- reg			: I2C slave address, (e.g. 0x6C).
+- interrupt-parent : Interrupt controller to which the chip is connected.
+- interrupts : Interrupt to which the chip is connected.
+
+Optional properties:
+- vdd-supply	: It is the controller supply for controlling
+					 main voltage(3.3V) through the regulator.
+- vid-supply	: It is the controller supply for controlling
+					IO voltage(1.8V) through the regulator.
+- reset-gpios	: Define for reset gpio pin.
+						It is to use for reset IC.
+- touchscreen-size-x	: X axis size of touchscreen
+- touchscreen-size-y	: Y axis size of touchscreen
+- linux,keycodes	: Specifies an array of numeric keycode values to
+			be used for reporting button presses. The array can
+			contain up to 3 entries.
+
+Example:
+
+#include "dt-bindings/input/input.h"
+
+i2c@00000000 {
+
+	/* ... */
+
+	touchscreen@6c {
+		compatible = "hideep,hideep-ts";
+		reg = <0x6c>;
+		interrupt-parent = <&gpx1>;
+		interrupts = <2 IRQ_TYPE_LEVEL_LOW>;
+		vdd-supply = <&ldo15_reg>";
+		vid-supply = <&ldo18_reg>;
+		reset-gpios = <&gpx1 5 0>;
+		touchscreen-size-x = <1080>;
+		touchscreen-size-y = <1920>;
+		linux,keycodes = <KEY_HOME>, <KEY_MENU>, <KEY_BACK>;
+	};
+};

Documentation/devicetree/bindings/vendor-prefixes.txt

@@ -137,6 +137,7 @@ gw	Gateworks Corporation
 hannstar	HannStar Display Corporation
 haoyu	Haoyu Microelectronic Co. Ltd.
 hardkernel	Hardkernel Co., Ltd
+hideep	HiDeep Inc.
 himax	Himax Technologies, Inc.
 hisilicon	Hisilicon Limited.
 hit	Hitachi Ltd.

drivers/input/touchscreen/Kconfig

@@ -354,6 +354,17 @@ config TOUCHSCREEN_GOODIX
 	  To compile this driver as a module, choose M here: the
 	  module will be called goodix.
 
+config TOUCHSCREEN_HIDEEP
+	tristate "HiDeep Touch IC"
+	depends on I2C
+	help
+	  Say Y here if you have a touchscreen using HiDeep.
+
+	  If unsure, say N.
+
+	  To compile this driver as a moudle, choose M here : the
+	  module will be called hideep_ts.
+
 config TOUCHSCREEN_ILI210X
 	tristate "Ilitek ILI210X based touchscreen"
 	depends on I2C

drivers/input/touchscreen/Makefile

@@ -41,6 +41,7 @@ obj-$(CONFIG_TOUCHSCREEN_EGALAX_SERIAL)	+= egalax_ts_serial.o
 obj-$(CONFIG_TOUCHSCREEN_EXC3000)	+= exc3000.o
 obj-$(CONFIG_TOUCHSCREEN_FUJITSU)	+= fujitsu_ts.o
 obj-$(CONFIG_TOUCHSCREEN_GOODIX)	+= goodix.o
+obj-$(CONFIG_TOUCHSCREEN_HIDEEP)	+= hideep.o
 obj-$(CONFIG_TOUCHSCREEN_ILI210X)	+= ili210x.o
 obj-$(CONFIG_TOUCHSCREEN_IMX6UL_TSC)	+= imx6ul_tsc.o
 obj-$(CONFIG_TOUCHSCREEN_INEXIO)	+= inexio.o