drm/msm/hdmi: Use pinctrl in HDMI driver

Some targets (eg: msm8994) use the pinctrl framework to configure
interface pins. This change adds support for initialization and
pinctrl active/sleep state control for the HDMI driver.
Signed-off-by: Stephane Viau <sviau@codeaurora.org>
Signed-off-by: Rob Clark <robdclark@gmail.com>

Documentation/devicetree/bindings/drm/msm/hdmi.txt

@@ -20,6 +20,9 @@ Required properties:
 Optional properties:
 - qcom,hdmi-tx-mux-en-gpio: hdmi mux enable pin
 - qcom,hdmi-tx-mux-sel-gpio: hdmi mux select pin
+- pinctrl-names: the pin control state names; should contain "default"
+- pinctrl-0: the default pinctrl state (active)
+- pinctrl-1: the "sleep" pinctrl state
 
 Example:
 
@@ -44,5 +47,8 @@ Example:
 		qcom,hdmi-tx-hpd = <&msmgpio 72 GPIO_ACTIVE_HIGH>;
 		core-vdda-supply = <&pm8921_hdmi_mvs>;
 		hdmi-mux-supply = <&ext_3p3v>;
+		pinctrl-names = "default", "sleep";
+		pinctrl-0 = <&hpd_active  &ddc_active  &cec_active>;
+		pinctrl-1 = <&hpd_suspend &ddc_suspend &cec_suspend>;
 	};
 };

drivers/gpu/drm/msm/hdmi/hdmi_connector.c

@@ -16,6 +16,7 @@
  */
 
 #include <linux/gpio.h>
+#include <linux/pinctrl/consumer.h>
 
 #include "msm_kms.h"
 #include "hdmi.h"
@@ -150,6 +151,12 @@ static int hpd_enable(struct hdmi_connector *hdmi_connector)
 		}
 	}
 
+	ret = pinctrl_pm_select_default_state(dev);
+	if (ret) {
+		dev_err(dev, "pinctrl state chg failed: %d\n", ret);
+		goto fail;
+	}
+
 	ret = gpio_config(hdmi, true);
 	if (ret) {
 		dev_err(dev, "failed to configure GPIOs: %d\n", ret);
@@ -219,6 +226,10 @@ static void hdp_disable(struct hdmi_connector *hdmi_connector)
 	if (ret)
 		dev_warn(dev, "failed to unconfigure GPIOs: %d\n", ret);
 
+	ret = pinctrl_pm_select_sleep_state(dev);
+	if (ret)
+		dev_warn(dev, "pinctrl state chg failed: %d\n", ret);
+
 	for (i = 0; i < config->hpd_reg_cnt; i++) {
 		ret = regulator_disable(hdmi->hpd_regs[i]);
 		if (ret)