Commit 882dde8e authored by Meenakshi Venkataraman's avatar Meenakshi Venkataraman Committed by John W. Linville

iwlwifi: update BT traffic load states correctly

When BT traffic load changes from its
previous state, a new LQ command needs to be
sent down to the firmware. This needs to
be done only once per change. The state
variable that keeps track of this change is
last_bt_traffic_load. However, it was not
being updated when the change had been
handled. Not updating this variable was
causing a flood of advanced BT config
commands to be sent to the firmware. Fix
this.

Cc: stable@vger.kernel.org #2.6.38+
Signed-off-by: default avatarMeenakshi Venkataraman <meenakshi.venkataraman@intel.com>
Signed-off-by: default avatarWey-Yi Guy <wey-yi.w.guy@intel.com>
Signed-off-by: default avatarJohannes Berg <johannes.berg@intel.com>
Signed-off-by: default avatarJohn W. Linville <linville@tuxdriver.com>
parent a0d0d168
...@@ -884,6 +884,7 @@ static void rs_bt_update_lq(struct iwl_priv *priv, struct iwl_rxon_context *ctx, ...@@ -884,6 +884,7 @@ static void rs_bt_update_lq(struct iwl_priv *priv, struct iwl_rxon_context *ctx,
if ((priv->bt_traffic_load != priv->last_bt_traffic_load) || if ((priv->bt_traffic_load != priv->last_bt_traffic_load) ||
(priv->bt_full_concurrent != full_concurrent)) { (priv->bt_full_concurrent != full_concurrent)) {
priv->bt_full_concurrent = full_concurrent; priv->bt_full_concurrent = full_concurrent;
priv->last_bt_traffic_load = priv->bt_traffic_load;
/* Update uCode's rate table. */ /* Update uCode's rate table. */
tbl = &(lq_sta->lq_info[lq_sta->active_tbl]); tbl = &(lq_sta->lq_info[lq_sta->active_tbl]);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment