arm64: dts: amlogic: remove ethernet-phy-idAAAA.BBBB compatible strings

The Ethernet PHY documentation
(Documentation/devicetree/bindings/net/phy.txt) states that:
  If the PHY reports an incorrect ID (or none at all) then the
  "compatible" list may contain an entry with the correct PHY ID in the
  form: "ethernet-phy-idAAAA.BBBB"

An older version of the documentation suggested that the compatible
string can be used when the PHY ID is known.

Remove the ethernet-phy-id compatible string and add a comment with the
PHY ID instead.
This is a no-op on boards which are shipped with the PHY that was
listed (= all known cases). However, if a board manufacturer decides to
ship a different PHY we will now load and use the correct driver because
we ask the PHY to identify itself.
Signed-off-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Kevin Hilman <khilman@baylibre.com>

arch/arm64/boot/dts/amlogic/meson-gxl-s905d-p230.dts

@@ -81,7 +81,7 @@ &ethmac {
 
 &external_mdio {
 	external_phy: ethernet-phy@0 {
-		compatible = "ethernet-phy-id001c.c916", "ethernet-phy-ieee802.3-c22";
+		/* Realtek RTL8211F (0x001cc916) */
 		reg = <0>;
 		max-speed = <1000>;
 		interrupt-parent = <&gpio_intc>;

arch/arm64/boot/dts/amlogic/meson-gxm-nexbox-a1.dts

@@ -111,7 +111,7 @@ &ethmac {
 
 &external_mdio {
 	external_phy: ethernet-phy@0 {
-		compatible = "ethernet-phy-id001c.c916", "ethernet-phy-ieee802.3-c22";
+		/* Realtek RTL8211F (0x001cc916) */
 		reg = <0>;
 		max-speed = <1000>;
 	};

arch/arm64/boot/dts/amlogic/meson-gxm-q200.dts

@@ -63,7 +63,7 @@ &ethmac {
 
 &external_mdio {
 	external_phy: ethernet-phy@0 {
-		compatible = "ethernet-phy-id001c.c916", "ethernet-phy-ieee802.3-c22";
+		/* Realtek RTL8211F (0x001cc916) */
 		reg = <0>;
 		max-speed = <1000>;
 		interrupt-parent = <&gpio_intc>;

arch/arm64/boot/dts/amlogic/meson-gxm-rbox-pro.dts

@@ -113,7 +113,7 @@ &ethmac {
 
 &external_mdio {
 	external_phy: ethernet-phy@0 {
-		compatible = "ethernet-phy-id001c.c916", "ethernet-phy-ieee802.3-c22";
+		/* Realtek RTL8211F (0x001cc916) */
 		reg = <0>;
 		max-speed = <1000>;
 	};