mmc: omap: restore original power up/down steps

Commit e519f0bb ("ARM/mmc: Convert old mmci-omap to GPIO descriptors")
moved Nokia N810 MMC power up/down from the board file into the MMC driver.

The change removed some delays, and ordering without a valid reason.
Restore power up/down to match the original code. This matters only on N810
where the 2nd GPIO is in use. Other boards will see an additional delay but
that should be a lesser concern than omitting delays altogether.

Fixes: e519f0bb ("ARM/mmc: Convert old mmci-omap to GPIO descriptors")
Signed-off-by: Aaro Koskinen <aaro.koskinen@iki.fi>
Message-ID: <20240223181439.1099750-6-aaro.koskinen@iki.fi>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Acked-by: Ulf Hansson <ulf.hansson@linaro.org>
Signed-off-by: Tony Lindgren <tony@atomide.com>

drivers/mmc/host/omap.c

@@ -1119,10 +1119,25 @@ static void mmc_omap_set_power(struct mmc_omap_slot *slot, int power_on,
 
 	host = slot->host;
 
-	if (slot->vsd)
-		gpiod_set_value(slot->vsd, power_on);
-	if (slot->vio)
-		gpiod_set_value(slot->vio, power_on);
+	if (power_on) {
+		if (slot->vsd) {
+			gpiod_set_value(slot->vsd, power_on);
+			msleep(1);
+		}
+		if (slot->vio) {
+			gpiod_set_value(slot->vio, power_on);
+			msleep(1);
+		}
+	} else {
+		if (slot->vio) {
+			gpiod_set_value(slot->vio, power_on);
+			msleep(50);
+		}
+		if (slot->vsd) {
+			gpiod_set_value(slot->vsd, power_on);
+			msleep(50);
+		}
+	}
 
 	if (slot->pdata->set_power != NULL)
 		slot->pdata->set_power(mmc_dev(slot->mmc), slot->id, power_on,