Commit 8a092e68 authored by Mika Båtsman's avatar Mika Båtsman Committed by Mark Brown

regulator: anatop: allow regulator to be in bypass mode

Bypass support was added in commit d38018f2 ("regulator: anatop: Add
bypass support to digital LDOs"). A check for valid voltage selectors was
added in commit da0607c8 ("regulator: anatop: Fail on invalid voltage
selector") but it also discards all regulators that are in bypass mode. Add
check for the bypass setting. Errors below were seen on a Variscite mx6
board.

anatop_regulator 20c8000.anatop:regulator-vddcore@140: Failed to read a valid default voltage selector.
anatop_regulator: probe of 20c8000.anatop:regulator-vddcore@140 failed with error -22
anatop_regulator 20c8000.anatop:regulator-vddsoc@140: Failed to read a valid default voltage selector.
anatop_regulator: probe of 20c8000.anatop:regulator-vddsoc@140 failed with error -22

Fixes: da0607c8 ("regulator: anatop: Fail on invalid voltage selector")
Signed-off-by: default avatarMika Båtsman <mbatsman@mvista.com>
Signed-off-by: default avatarMark Brown <broonie@kernel.org>
parent 1a695a90
...@@ -296,7 +296,7 @@ static int anatop_regulator_probe(struct platform_device *pdev) ...@@ -296,7 +296,7 @@ static int anatop_regulator_probe(struct platform_device *pdev)
if (!sreg->sel && !strcmp(sreg->name, "vddpu")) if (!sreg->sel && !strcmp(sreg->name, "vddpu"))
sreg->sel = 22; sreg->sel = 22;
if (!sreg->sel) { if (!sreg->bypass && !sreg->sel) {
dev_err(&pdev->dev, "Failed to read a valid default voltage selector.\n"); dev_err(&pdev->dev, "Failed to read a valid default voltage selector.\n");
return -EINVAL; return -EINVAL;
} }
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment