Commit 8d813941 authored by René Bürgel's avatar René Bürgel Committed by Paul Mackerras

[POWERPC] Fix MPC5200 (not B!) device tree so FEC ethernet works

This gets the FEC ethernet driver working again on the lite5200
platform.

The FEC driver is also compatible with the MPC5200, not only with the
MPC5200B, so this adds a suitable entry to the driver's match list.
Furthermore this adds the settings for the PHY in the dts file for the
Lite5200.  Note, that this is not exactly the same as in the
Lite5200B, because the PHY is located at f0003000:01 for the 5200, and
at :00 for the 5200B.  This was tested on a Lite5200 and a Lite5200B,
both booted a kernel via tftp and mounted the root via nfs
successfully.
Signed-off-by: default avatarRené Bürgel <r.buergel@unicontrol.de>
Acked-by: default avatarGrant Likely <grant.likely@secretlab.ca>
Signed-off-by: default avatarPaul Mackerras <paulus@samba.org>
parent 115e1adc
......@@ -258,6 +258,21 @@ ethernet@3000 {
local-mac-address = [ 00 00 00 00 00 00 ];
interrupts = <2 5 0>;
interrupt-parent = <&mpc5200_pic>;
phy-handle = <&phy0>;
};
mdio@3000 {
#address-cells = <1>;
#size-cells = <0>;
compatible = "fsl,mpc5200-mdio";
reg = <3000 400>; // fec range, since we need to setup fec interrupts
interrupts = <2 5 0>; // these are for "mii command finished", not link changes & co.
interrupt-parent = <&mpc5200_pic>;
phy0:ethernet-phy@1 {
device_type = "ethernet-phy";
reg = <1>;
};
};
ata@3a00 {
......
......@@ -1057,6 +1057,7 @@ static int mpc52xx_fec_of_resume(struct of_device *op)
#endif
static struct of_device_id mpc52xx_fec_match[] = {
{ .type = "network", .compatible = "fsl,mpc5200b-fec", },
{ .type = "network", .compatible = "fsl,mpc5200-fec", },
{ .type = "network", .compatible = "mpc5200-fec", },
{ }
......
......@@ -179,6 +179,7 @@ static int mpc52xx_fec_mdio_remove(struct of_device *of)
static struct of_device_id mpc52xx_fec_mdio_match[] = {
{ .compatible = "fsl,mpc5200b-mdio", },
{ .compatible = "fsl,mpc5200-mdio", },
{ .compatible = "mpc5200b-fec-phy", },
{}
};
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment