leds: renesas: set gpio_request_one() flags param correctly

The gpio_request_one() flags parameter was set to:

  GPIOF_DIR_OUT | !!brightness

GPIOF_DIR_OUT and GPIOF_DIR_IN are defined as below:
  GPIOF_DIR_OUT   (0 << 0)
  GPIOF_DIR_IN    (1 << 0)

So, when '!!brightness' is 1, the gpio pin can be set as input,
instead of output.

To prevent this problem, GPIOF_OUT_INIT flags should be used when
using gpio_request_one().
Signed-off-by: Jingoo Han <jg1.han@samsung.com>
Signed-off-by: Bryan Wu <cooloney@gmail.com>

drivers/leds/leds-renesas-tpu.c

@@ -205,7 +205,8 @@ static void r_tpu_set_pin(struct r_tpu_priv *p, enum r_tpu_pin new_state,
 		gpio_free(cfg->pin_gpio_fn);
 
 	if (new_state == R_TPU_PIN_GPIO)
-		gpio_request_one(cfg->pin_gpio, GPIOF_DIR_OUT | !!brightness,
+		gpio_request_one(cfg->pin_gpio, !!brightness ?
+				GPIOF_OUT_INIT_HIGH : GPIOF_OUT_INIT_LOW,
 				cfg->name);
 
 	if (new_state == R_TPU_PIN_GPIO_FN)