Commit 90225bf0 authored by Grygorii Strashko's avatar Grygorii Strashko Committed by David S. Miller

net: ethernet: ti: cpsw: add support for descs pool size configuration

The CPSW CPDMA can process buffer descriptors placed as in internal
CPPI RAM as in DDR. This patch adds support in CPSW and CPDMA for
descs_pool_size mudule parameter, which defines total number of CPDMA CPPI
descriptors to be used for both ingress/egress packets processing:
 - memory size, required for CPDMA descriptor pool, is calculated basing
on number of descriptors specified by user in descs_pool_size and
CPDMA descriptor size and allocated from coherent memory (CMA area);
 - CPDMA descriptor pool will be allocated in DDR if pool memory size >
internal CPPI RAM or use internal CPPI RAM otherwise;
 - if descs_pool_size not specified in DT - the default value 256 will
be used which will allow to place CPDMA descriptors pool into the
internal CPPI RAM (current default behaviour);
 - CPDMA will ignore descs_pool_size if descs_pool_size = 0 for
backward comaptiobility with davinci_emac.

descs_pool_size is boot time setting and can't be changed once
CPSW/CPDMA is initialized.
Signed-off-by: default avatarGrygorii Strashko <grygorii.strashko@ti.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 7f3b490a
......@@ -145,6 +145,7 @@ do { \
cpsw->data.active_slave)
#define IRQ_NUM 2
#define CPSW_MAX_QUEUES 8
#define CPSW_CPDMA_DESCS_POOL_SIZE_DEFAULT 256
static int debug_level;
module_param(debug_level, int, 0);
......@@ -158,6 +159,10 @@ static int rx_packet_max = CPSW_MAX_PACKET_SIZE;
module_param(rx_packet_max, int, 0);
MODULE_PARM_DESC(rx_packet_max, "maximum receive packet size (bytes)");
static int descs_pool_size = CPSW_CPDMA_DESCS_POOL_SIZE_DEFAULT;
module_param(descs_pool_size, int, 0444);
MODULE_PARM_DESC(descs_pool_size, "Number of CPDMA CPPI descriptors in pool");
struct cpsw_wr_regs {
u32 id_ver;
u32 soft_reset;
......@@ -2969,6 +2974,7 @@ static int cpsw_probe(struct platform_device *pdev)
dma_params.has_ext_regs = true;
dma_params.desc_hw_addr = dma_params.desc_mem_phys;
dma_params.bus_freq_mhz = cpsw->bus_freq_mhz;
dma_params.descs_pool_size = descs_pool_size;
cpsw->dma = cpdma_ctlr_create(&dma_params);
if (!cpsw->dma) {
......@@ -3072,9 +3078,9 @@ static int cpsw_probe(struct platform_device *pdev)
goto clean_ale_ret;
}
cpsw_notice(priv, probe, "initialized device (regs %pa, irq %d)\n",
&ss_res->start, ndev->irq);
cpsw_notice(priv, probe,
"initialized device (regs %pa, irq %d, pool size %d)\n",
&ss_res->start, ndev->irq, dma_params.descs_pool_size);
if (cpsw->data.dual_emac) {
ret = cpsw_probe_dual_emac(priv);
if (ret) {
......
......@@ -219,6 +219,18 @@ int cpdma_desc_pool_create(struct cpdma_ctlr *ctlr)
cpdma_params->desc_align);
pool->num_desc = pool->mem_size / pool->desc_size;
if (cpdma_params->descs_pool_size) {
/* recalculate memory size required cpdma descriptor pool
* basing on number of descriptors specified by user and
* if memory size > CPPI internal RAM size (desc_mem_size)
* then switch to use DDR
*/
pool->num_desc = cpdma_params->descs_pool_size;
pool->mem_size = pool->desc_size * pool->num_desc;
if (pool->mem_size > cpdma_params->desc_mem_size)
cpdma_params->desc_mem_phys = 0;
}
pool->gen_pool = devm_gen_pool_create(ctlr->dev, ilog2(pool->desc_size),
-1, "cpdma");
if (IS_ERR(pool->gen_pool)) {
......
......@@ -37,6 +37,7 @@ struct cpdma_params {
int desc_mem_size;
int desc_align;
u32 bus_freq_mhz;
u32 descs_pool_size;
/*
* Some instances of embedded cpdma controllers have extra control and
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment