cpufreq: intel_pstate: Set asymmetric CPU capacity on hybrid systems
Make intel_pstate use the HWP_HIGHEST_PERF values from MSR_HWP_CAPABILITIES to set asymmetric CPU capacity information via the previously introduced arch_set_cpu_capacity() on hybrid systems without SMT. Setting asymmetric CPU capacity is generally necessary to allow the scheduler to compute task sizes in a consistent way across all CPUs in a system where they differ by capacity. That, in turn, should help to improve scheduling decisions. It is also necessary for the schedutil cpufreq governor to operate as expected on hybrid systems where tasks migrate between CPUs of different capacities. The underlying observation is that intel_pstate already uses MSR_HWP_CAPABILITIES to get CPU performance information which is exposed by it via sysfs and CPU performance scaling is based on it. Thus using this information for setting asymmetric CPU capacity is consistent with what the driver has been doing already. Moreover, HWP_HIGHEST_PERF reflects the maximum capacity of a given CPU including both the instructions-per-cycle (IPC) factor and the maximum turbo frequency and the units in which that value is expressed are the same for all CPUs in the system, so the maximum capacity ratio between two CPUs can be obtained by computing the ratio of their HWP_HIGHEST_PERF values. Of course, in principle that capacity ratio need not be directly applicable at lower frequencies, so using it for providing the asymmetric CPU capacity information to the scheduler is a rough approximation, but it is as good as it gets. Also, measurements indicate that this approximation is not too bad in practice. If the given system is hybrid and non-SMT, the new code disables ITMT support in the scheduler (because it may get in the way of asymmetric CPU capacity code in the scheduler that automatically gets enabled by setting asymmetric CPU capacity) after initializing all online CPUs and finds the one with the maximum HWP_HIGHEST_PERF value. Next, it computes the capacity number for each (online) CPU by dividing the product of its HWP_HIGHEST_PERF and SCHED_CAPACITY_SCALE by the maximum HWP_HIGHEST_PERF. When a CPU goes offline, its capacity is reset to SCHED_CAPACITY_SCALE and if it is the one with the maximum HWP_HIGHEST_PERF value, the capacity numbers for all of the other online CPUs are recomputed. This also takes care of a cleanup during driver operation mode changes. Analogously, when a new CPU goes online, its capacity number is updated and if its HWP_HIGHEST_PERF value is greater than the current maximum one, the capacity numbers for all of the other online CPUs are recomputed. The case when the driver is notified of a CPU capacity change, either through the HWP interrupt or through an ACPI notification, is handled similarly to the CPU online case above, except that if the target CPU is the current highest-capacity one and its capacity is reduced, the capacity numbers for all of the other online CPUs need to be recomputed either. If the driver's "no_trubo" sysfs attribute is updated, all of the CPU capacity information is computed from scratch to reflect the new turbo status. Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com> Reviewed-by: Ricardo Neri <ricardo.neri-calderon@linux.intel.com> Tested-by: Ricardo Neri <ricardo.neri-calderon@linux.intel.com> # scale invariance Link: https://patch.msgid.link/1979653.PYKUYFuaPT@rjwysocki.net [ rjw: Fixed a typo in the changelog ] [ rjw: Renamed 3 new functions and added a comment ] Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com>
Showing
Please register or sign in to comment