Commit 92da01a0 authored by Jonathan Cameron's avatar Jonathan Cameron

staging:iio:TODO drop outdated entries in this todo.

There is still stuff to be done in the remaining drivers but pretty much
nothing was left from this original TODO.

Sorry Greg, should have been keeping this up to date.
Signed-off-by: default avatarJonathan Cameron <jic23@kernel.org>
Acked-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent f08a1508
2009 8/18 2016 10/09
Core:
1) Get reviews
2) Additional testing
3) Ensure all desirable features present by adding more devices.
Major changes not expected except in response to comments
Max1363 core:
1) Possibly add sysfs exports of constant useful to userspace.
Would be nice
2) Support hardware generated interrupts
3) Expand device set. Lots of other maxim adc's have very
similar interfaces.
MXS LRADC driver:
This is a classic MFD device as it combines the following subdevices
- touchscreen controller (input subsystem related device)
- general purpose ADC channels
- battery voltage monitor (power subsystem related device)
- die temperature monitor (thermal management)
At least the battery voltage and die temperature feature is required in-kernel
by a driver of the SoC's battery charging unit to avoid any damage to the
silicon and the battery.
TSL2561
Would be nice
1) Open question of userspace vs kernel space balance when
converting to useful light measurements from device ones.
2) Add sysfs elements necessary to allow device agnostic
unit conversion.
LIS3L02DQ core
LIS3L02DQ ring
KXSD9
Currently minimal driver, would be nice to add:
1) Support for all chip generated interrupts (events),
basically get support up to level of lis3l02dq driver.
Ring buffer core
SCA3000
Would be nice
1) Testing on devices other than sca3000-e05
Trigger core support
1) Discussion of approach. Is it general enough?
Ring Buffer:
1) Discussion of approach.
There are probably better ways of doing this. The
intention is to allow for more than one software ring
buffer implementation as different users will have
different requirements. This one suits mid range
frequencies (100Hz - 4kHz).
2) Lots of testing
GPIO trigger
1) Add control over the type of interrupt etc. This will
necessitate a header that is also visible from arch board
files. (avoided at the moment to keep the driver set
contained in staging).
ADI Drivers: ADI Drivers:
CC the device-drivers-devel@blackfin.uclinux.org mailing list when CC the device-drivers-devel@blackfin.uclinux.org mailing list when
e-mailing the normal IIO list (see below). e-mailing the normal IIO list (see below).
Documentation
1) Lots of cleanup and expansion.
2) Some device require individual docs.
Contact: Jonathan Cameron <jic23@kernel.org>. Contact: Jonathan Cameron <jic23@kernel.org>.
Mailing list: linux-iio@vger.kernel.org Mailing list: linux-iio@vger.kernel.org
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment