Commit 990a142e authored by Richard Genoud's avatar Richard Genoud Committed by Greg Kroah-Hartman

tty/serial: atmel: RS485 half duplex w/DMA: enable RX after TX is done

commit b389f173 upstream.

When using RS485 in half duplex, RX should be enabled when TX is
finished, and stopped when TX starts.

Before commit 0058f087 ("tty/serial: atmel: fix RS485 half
duplex with DMA"), RX was not disabled in atmel_start_tx() if the DMA
was used. So, collisions could happened.

But disabling RX in atmel_start_tx() uncovered another bug:
RX was enabled again in the wrong place (in atmel_tx_dma) instead of
being enabled when TX is finished (in atmel_complete_tx_dma), so the
transmission simply stopped.

This bug was not triggered before commit 0058f087
("tty/serial: atmel: fix RS485 half duplex with DMA") because RX was
never disabled before.

Moving atmel_start_rx() in atmel_complete_tx_dma() corrects the problem.
Reported-by: default avatarGil Weber <webergil@gmail.com>
Fixes: 0058f087Tested-by: default avatarGil Weber <webergil@gmail.com>
Signed-off-by: default avatarRichard Genoud <richard.genoud@gmail.com>
Acked-by: default avatarAlexandre Belloni <alexandre.belloni@free-electrons.com>
Signed-off-by: default avatarAlexandre Belloni <alexandre.belloni@free-electrons.com>
Tested-by: default avatarBryan Evenson <bevenson@melinkcorp.com>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent 8dc821b9
......@@ -810,6 +810,11 @@ static void atmel_complete_tx_dma(void *arg)
*/
if (!uart_circ_empty(xmit))
tasklet_schedule(&atmel_port->tasklet);
else if ((port->rs485.flags & SER_RS485_ENABLED) &&
!(port->rs485.flags & SER_RS485_RX_DURING_TX)) {
/* DMA done, stop TX, start RX for RS485 */
atmel_start_rx(port);
}
spin_unlock_irqrestore(&port->lock, flags);
}
......@@ -912,12 +917,6 @@ static void atmel_tx_dma(struct uart_port *port)
desc->callback = atmel_complete_tx_dma;
desc->callback_param = atmel_port;
atmel_port->cookie_tx = dmaengine_submit(desc);
} else {
if (port->rs485.flags & SER_RS485_ENABLED) {
/* DMA done, stop TX, start RX for RS485 */
atmel_start_rx(port);
}
}
if (uart_circ_chars_pending(xmit) < WAKEUP_CHARS)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment