Commit 9a5ab0f4 authored by Rajkumar Manoharan's avatar Rajkumar Manoharan Committed by Kalle Valo

ath10k: fix rts profile for second rate series

By default rts protection is enabled in firmware for the second
rateset. Currently ath10k selects RTS profile (only for software
retries), when legacy stations are associated or asked by mac80211.
On congested environment, when AP is running in HT/VHT mode and
there are no legacy clients associated, this will impact the
robustness. Also enabling RTS protection only for second rateset will
not impact performance on clear environment. Fix that.
Signed-off-by: default avatarRajkumar Manoharan <rmanohar@qti.qualcomm.com>
Signed-off-by: default avatarKalle Valo <kvalo@qca.qualcomm.com>
parent 37a0b394
......@@ -881,12 +881,14 @@ static int ath10k_recalc_rtscts_prot(struct ath10k_vif *arvif)
vdev_param = ar->wmi.vdev_param->enable_rtscts;
if (arvif->use_cts_prot || arvif->num_legacy_stations > 0)
rts_cts |= SM(WMI_RTSCTS_ENABLED, WMI_RTSCTS_SET);
rts_cts |= SM(WMI_RTSCTS_ENABLED, WMI_RTSCTS_SET);
if (arvif->num_legacy_stations > 0)
rts_cts |= SM(WMI_RTSCTS_ACROSS_SW_RETRIES,
WMI_RTSCTS_PROFILE);
else
rts_cts |= SM(WMI_RTSCTS_FOR_SECOND_RATESERIES,
WMI_RTSCTS_PROFILE);
return ath10k_wmi_vdev_set_param(ar, arvif->vdev_id, vdev_param,
rts_cts);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment