Commit 9c06ac4c authored by Keiya Nobuta's avatar Keiya Nobuta Committed by Greg Kroah-Hartman

usb: core: hub: Improved device recognition on remote wakeup

If hub_activate() is called before D+ has stabilized after remote
wakeup, the following situation might occur:

         __      ___________________
        /  \    /
D+   __/    \__/

Hub  _______________________________
          |  ^   ^           ^
          |  |   |           |
Host _____v__|___|___________|______
          |  |   |           |
          |  |   |           \-- Interrupt Transfer (*3)
          |  |    \-- ClearPortFeature (*2)
          |   \-- GetPortStatus (*1)
          \-- Host detects remote wakeup

- D+ goes high, Host starts running by remote wakeup
- D+ is not stable, goes low
- Host requests GetPortStatus at (*1) and gets the following hub status:
  - Current Connect Status bit is 0
  - Connect Status Change bit is 1
- D+ stabilizes, goes high
- Host requests ClearPortFeature and thus Connect Status Change bit is
  cleared at (*2)
- After waiting 100 ms, Host starts the Interrupt Transfer at (*3)
- Since the Connect Status Change bit is 0, Hub returns NAK.

In this case, port_event() is not called in hub_event() and Host cannot
recognize device. To solve this issue, flag change_bits even if only
Connect Status Change bit is 1 when got in the first GetPortStatus.

This issue occurs rarely because it only if D+ changes during a very
short time between GetPortStatus and ClearPortFeature. However, it is
fatal if it occurs in embedded system.
Signed-off-by: default avatarKeiya Nobuta <nobuta.keiya@fujitsu.com>
Cc: stable <stable@vger.kernel.org>
Acked-by: default avatarAlan Stern <stern@rowland.harvard.edu>
Link: https://lore.kernel.org/r/20200109051448.28150-1-nobuta.keiya@fujitsu.comSigned-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent b3a987b0
......@@ -1192,6 +1192,7 @@ static void hub_activate(struct usb_hub *hub, enum hub_activation_type type)
* PORT_OVER_CURRENT is not. So check for any of them.
*/
if (udev || (portstatus & USB_PORT_STAT_CONNECTION) ||
(portchange & USB_PORT_STAT_C_CONNECTION) ||
(portstatus & USB_PORT_STAT_OVERCURRENT) ||
(portchange & USB_PORT_STAT_C_OVERCURRENT))
set_bit(port1, hub->change_bits);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment