Commit 9c15795a authored by Emiliano Ingrassia's avatar Emiliano Ingrassia Committed by Kevin Hilman

ARM: dts: meson8b-odroidc1: ethernet support

The Odroid-C1+ board is equipped with an RTL8211F ethernet PHY
which supports 10/100/1000 Mbps ethernet.
The PHY reset and interrupt lines are controlled by the SoC via
two GPIO lines (GPIOH_4 and GPIOH_3 respectively).
The PHY energy efficient ethernet (eee) mode is marked as broken
using "eee-broken-1000t" because, during tests, high packet losses
were experienced without it.
Signed-off-by: default avatarEmiliano Ingrassia <ingrassia@epigenesys.com>
Tested-by: default avatarLinus Lüssing <linus.luessing@c0d3.blue>
Reviewed-by: default avatarMartin Blumenstingl <martin.blumenstingl@googlemail.com>
Signed-off-by: default avatarKevin Hilman <khilman@baylibre.com>
parent b9644654
...@@ -99,3 +99,33 @@ &usb1_phy { ...@@ -99,3 +99,33 @@ &usb1_phy {
&usb1 { &usb1 {
status = "okay"; status = "okay";
}; };
&ethmac {
status = "okay";
snps,reset-gpio = <&gpio GPIOH_4 GPIO_ACTIVE_HIGH>;
snps,reset-active-low;
snps,reset-delays-us = <0 10000 30000>;
pinctrl-0 = <&eth_rgmii_pins>;
pinctrl-names = "default";
phy-mode = "rgmii";
phy-handle = <&eth_phy>;
amlogic,tx-delay-ns = <4>;
mdio {
compatible = "snps,dwmac-mdio";
#address-cells = <1>;
#size-cells = <0>;
/* Realtek RTL8211F (0x001cc916) */
eth_phy: ethernet-phy@0 {
reg = <0>;
eee-broken-1000t;
interrupt-parent = <&gpio_intc>;
/* GPIOH_3 */
interrupts = <17 IRQ_TYPE_LEVEL_LOW>;
};
};
};
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment