Commit 9d2ee0a6 authored by Kamal Dasu's avatar Kamal Dasu Committed by Boris Brezillon

mtd: nand: brcmnand: Check flash #WP pin status before nand erase/program

On brcmnand controller v6.x and v7.x, the #WP pin is controlled through
the NAND_WP bit in CS_SELECT register.

The driver currently assumes that toggling the #WP pin is
instantaneously enabling/disabling write-protection, but it actually
takes some time to propagate the new state to the internal NAND chip
logic. This behavior is sometime causing data corruptions when an
erase/program operation is executed before write-protection has really
been disabled.

Fixes: 27c5b17c ("mtd: nand: add NAND driver "library" for Broadcom STB NAND controller")
Signed-off-by: default avatarKamal Dasu <kdasu.kdev@gmail.com>
Signed-off-by: default avatarBoris Brezillon <boris.brezillon@free-electrons.com>
parent 65a2c1ca
......@@ -101,6 +101,9 @@ struct brcm_nand_dma_desc {
#define BRCMNAND_MIN_BLOCKSIZE (8 * 1024)
#define BRCMNAND_MIN_DEVSIZE (4ULL * 1024 * 1024)
#define NAND_CTRL_RDY (INTFC_CTLR_READY | INTFC_FLASH_READY)
#define NAND_POLL_STATUS_TIMEOUT_MS 100
/* Controller feature flags */
enum {
BRCMNAND_HAS_1K_SECTORS = BIT(0),
......@@ -765,6 +768,31 @@ enum {
CS_SELECT_AUTO_DEVICE_ID_CFG = BIT(30),
};
static int bcmnand_ctrl_poll_status(struct brcmnand_controller *ctrl,
u32 mask, u32 expected_val,
unsigned long timeout_ms)
{
unsigned long limit;
u32 val;
if (!timeout_ms)
timeout_ms = NAND_POLL_STATUS_TIMEOUT_MS;
limit = jiffies + msecs_to_jiffies(timeout_ms);
do {
val = brcmnand_read_reg(ctrl, BRCMNAND_INTFC_STATUS);
if ((val & mask) == expected_val)
return 0;
cpu_relax();
} while (time_after(limit, jiffies));
dev_warn(ctrl->dev, "timeout on status poll (expected %x got %x)\n",
expected_val, val & mask);
return -ETIMEDOUT;
}
static inline void brcmnand_set_wp(struct brcmnand_controller *ctrl, bool en)
{
u32 val = en ? CS_SELECT_NAND_WP : 0;
......@@ -1024,12 +1052,39 @@ static void brcmnand_wp(struct mtd_info *mtd, int wp)
if ((ctrl->features & BRCMNAND_HAS_WP) && wp_on == 1) {
static int old_wp = -1;
int ret;
if (old_wp != wp) {
dev_dbg(ctrl->dev, "WP %s\n", wp ? "on" : "off");
old_wp = wp;
}
/*
* make sure ctrl/flash ready before and after
* changing state of #WP pin
*/
ret = bcmnand_ctrl_poll_status(ctrl, NAND_CTRL_RDY |
NAND_STATUS_READY,
NAND_CTRL_RDY |
NAND_STATUS_READY, 0);
if (ret)
return;
brcmnand_set_wp(ctrl, wp);
chip->cmdfunc(mtd, NAND_CMD_STATUS, -1, -1);
/* NAND_STATUS_WP 0x00 = protected, 0x80 = not protected */
ret = bcmnand_ctrl_poll_status(ctrl,
NAND_CTRL_RDY |
NAND_STATUS_READY |
NAND_STATUS_WP,
NAND_CTRL_RDY |
NAND_STATUS_READY |
(wp ? 0 : NAND_STATUS_WP), 0);
if (ret)
dev_err_ratelimited(&host->pdev->dev,
"nand #WP expected %s\n",
wp ? "on" : "off");
}
}
......@@ -1157,15 +1212,15 @@ static irqreturn_t brcmnand_dma_irq(int irq, void *data)
static void brcmnand_send_cmd(struct brcmnand_host *host, int cmd)
{
struct brcmnand_controller *ctrl = host->ctrl;
u32 intfc;
int ret;
dev_dbg(ctrl->dev, "send native cmd %d addr_lo 0x%x\n", cmd,
brcmnand_read_reg(ctrl, BRCMNAND_CMD_ADDRESS));
BUG_ON(ctrl->cmd_pending != 0);
ctrl->cmd_pending = cmd;
intfc = brcmnand_read_reg(ctrl, BRCMNAND_INTFC_STATUS);
WARN_ON(!(intfc & INTFC_CTLR_READY));
ret = bcmnand_ctrl_poll_status(ctrl, NAND_CTRL_RDY, NAND_CTRL_RDY, 0);
WARN_ON(ret);
mb(); /* flush previous writes */
brcmnand_write_reg(ctrl, BRCMNAND_CMD_START,
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment