leds: bcm6328: Reuse bcm6328_led_set() instead of copying its functionality

When ensuring a consistent initial LED state in bcm6328_led (as they may
be blinking instead of on/off), the LED register is set using an inverted
copy of bcm6328_led_set(). To avoid further errors relating to active low
handling, call this function directly instead.

As bcm6328_led_set() acquires the same spinlock again when updating the
register, it is called after unlocking.
Signed-off-by: Simon Arlott <simon@fire.lp0.eu>
Signed-off-by: Jacek Anaszewski <j.anaszewski@samsung.com>

drivers/leds/leds-bcm6328.c

@@ -314,14 +314,10 @@ static int bcm6328_led(struct device *dev, struct device_node *nc, u32 reg,
 	} else {
 		led->cdev.brightness = LED_OFF;
 	}
-
-	if ((led->active_low && led->cdev.brightness == LED_FULL) ||
-	    (!led->active_low && led->cdev.brightness == LED_OFF))
-		bcm6328_led_mode(led, BCM6328_LED_MODE_ON);
-	else
-		bcm6328_led_mode(led, BCM6328_LED_MODE_OFF);
 	spin_unlock_irqrestore(lock, flags);
 
+	bcm6328_led_set(&led->cdev, led->cdev.brightness);
+
 	led->cdev.brightness_set = bcm6328_led_set;
 	led->cdev.blink_set = bcm6328_blink_set;