ixgbe: update PHY code to support 100Mbps as well as 1G/10G

This change updates the PHY setup code to support 100Mbps capable PHYs
as well as 10G and 1Gbps.
Signed-off-by: Emil Tantilov <emil.s.tantilov@intel.com>
Tested-by: Stephen Ko <stephen.s.ko@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ixgbe/ixgbe_82598.c

@@ -158,6 +158,7 @@ static s32 ixgbe_init_phy_ops_82598(struct ixgbe_hw *hw)
 
 	switch (hw->phy.type) {
 	case ixgbe_phy_tn:
+		phy->ops.setup_link = &ixgbe_setup_phy_link_tnx;
 		phy->ops.check_link = &ixgbe_check_phy_link_tnx;
 		phy->ops.get_firmware_version =
 		             &ixgbe_get_phy_firmware_version_tnx;

drivers/net/ixgbe/ixgbe_phy.h

@@ -108,6 +108,7 @@ s32 ixgbe_get_copper_link_capabilities_generic(struct ixgbe_hw *hw,
 s32 ixgbe_check_phy_link_tnx(struct ixgbe_hw *hw,
                              ixgbe_link_speed *speed,
                              bool *link_up);
+s32 ixgbe_setup_phy_link_tnx(struct ixgbe_hw *hw);
 s32 ixgbe_get_phy_firmware_version_tnx(struct ixgbe_hw *hw,
                                        u16 *firmware_version);
 s32 ixgbe_get_phy_firmware_version_generic(struct ixgbe_hw *hw,

drivers/net/ixgbe/ixgbe_type.h

@@ -1009,6 +1009,13 @@
 #define IXGBE_MDIO_PMA_PMD_SDA_SCL_DATA     0xC30B /* PHY_XS SDA/SCL Data Reg */
 #define IXGBE_MDIO_PMA_PMD_SDA_SCL_STAT     0xC30C /* PHY_XS SDA/SCL Status Reg */
 
+/* MII clause 22/28 definitions */
+#define IXGBE_MII_AUTONEG_VENDOR_PROVISION_1_REG 0xC400 /* 1G Provisioning 1 */
+#define IXGBE_MII_AUTONEG_XNP_TX_REG             0x17   /* 1G XNP Transmit */
+#define IXGBE_MII_1GBASE_T_ADVERTISE_XNP_TX      0x4000 /* full duplex, bit:14*/
+#define IXGBE_MII_1GBASE_T_ADVERTISE             0x8000 /* full duplex, bit:15*/
+#define IXGBE_MII_AUTONEG_REG                    0x0
+
 #define IXGBE_PHY_REVISION_MASK        0xFFFFFFF0
 #define IXGBE_MAX_PHY_ADDR             32