pwm: pca9685: Improve runtime PM behavior

The chip does not come out of POR in active state but in sleep state.
To be sure (in case the bootloader woke it up) we force it to sleep in
probe.

If runtime PM is disabled, we instead wake the chip in .probe and put it
to sleep in .remove.
Signed-off-by: Clemens Gruber <clemens.gruber@pqgruber.com>
Signed-off-by: Thierry Reding <thierry.reding@gmail.com>

drivers/pwm/pwm-pca9685.c

@@ -461,14 +461,20 @@ static int pca9685_pwm_probe(struct i2c_client *client,
 		return ret;
 	}
 
-	/* The chip comes out of power-up in the active state */
-	pm_runtime_set_active(&client->dev);
-	/*
-	 * Enable will put the chip into suspend, which is what we
-	 * want as all outputs are disabled at this point
-	 */
 	pm_runtime_enable(&client->dev);
 
+	if (pm_runtime_enabled(&client->dev)) {
+		/*
+		 * Although the chip comes out of power-up in the sleep state,
+		 * we force it to sleep in case it was woken up before
+		 */
+		pca9685_set_sleep_mode(pca, true);
+		pm_runtime_set_suspended(&client->dev);
+	} else {
+		/* Wake the chip up if runtime PM is disabled */
+		pca9685_set_sleep_mode(pca, false);
+	}
+
 	return 0;
 }
 
@@ -480,7 +486,14 @@ static int pca9685_pwm_remove(struct i2c_client *client)
 	ret = pwmchip_remove(&pca->chip);
 	if (ret)
 		return ret;
+
+	if (!pm_runtime_enabled(&client->dev)) {
+		/* Put chip in sleep state if runtime PM is disabled */
+		pca9685_set_sleep_mode(pca, true);
+	}
+
 	pm_runtime_disable(&client->dev);
+
 	return 0;
 }