tg3: Fix io failures after chip reset

Commit f2096f94, entitled
"tg3: Add 5720 H2BMC support", needed to add code to preserve some bits
set by firmware.  Unfortunately the new code causes throughput to stop
after a chip reset because it enables state machines before they are
ready.  This patch undoes the problematic code.  The bits will be
restored later in the init sequence.
Signed-off-by: Matt Carlson <mcarlson@broadcom.com>
Reviewed-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/tg3.c

@@ -7412,16 +7412,11 @@ static int tg3_chip_reset(struct tg3 *tp)
 		tw32(TG3PCI_CLOCK_CTRL, tp->pci_clock_ctrl);
 	}
 
-	if (tg3_flag(tp, ENABLE_APE))
-		tp->mac_mode = MAC_MODE_APE_TX_EN |
-			       MAC_MODE_APE_RX_EN |
-			       MAC_MODE_TDE_ENABLE;
-
 	if (tp->phy_flags & TG3_PHYFLG_PHY_SERDES) {
-		tp->mac_mode |= MAC_MODE_PORT_MODE_TBI;
+		tp->mac_mode = MAC_MODE_PORT_MODE_TBI;
 		val = tp->mac_mode;
 	} else if (tp->phy_flags & TG3_PHYFLG_MII_SERDES) {
-		tp->mac_mode |= MAC_MODE_PORT_MODE_GMII;
+		tp->mac_mode = MAC_MODE_PORT_MODE_GMII;
 		val = tp->mac_mode;
 	} else
 		val = 0;
@@ -8559,12 +8554,11 @@ static int tg3_reset_hw(struct tg3 *tp, int reset_phy)
 		udelay(10);
 	}
 
-	if (tg3_flag(tp, ENABLE_APE))
-		tp->mac_mode = MAC_MODE_APE_TX_EN | MAC_MODE_APE_RX_EN;
-	else
-		tp->mac_mode = 0;
 	tp->mac_mode |= MAC_MODE_TXSTAT_ENABLE | MAC_MODE_RXSTAT_ENABLE |
-		MAC_MODE_TDE_ENABLE | MAC_MODE_RDE_ENABLE | MAC_MODE_FHDE_ENABLE;
+			MAC_MODE_TDE_ENABLE | MAC_MODE_RDE_ENABLE |
+			MAC_MODE_FHDE_ENABLE;
+	if (tg3_flag(tp, ENABLE_APE))
+		tp->mac_mode |= MAC_MODE_APE_TX_EN | MAC_MODE_APE_RX_EN;
 	if (!tg3_flag(tp, 5705_PLUS) &&
 	    !(tp->phy_flags & TG3_PHYFLG_PHY_SERDES) &&
 	    GET_ASIC_REV(tp->pci_chip_rev_id) != ASIC_REV_5700)