net: phy: dp83822: Update the fiber advertisement for speed

Update the fiber advertisement for speed and duplex modes with the
100base-FX full and half linkmode entries.
Signed-off-by: Dan Murphy <dmurphy@ti.com>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Reviewed-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/phy/dp83822.c

@@ -110,9 +110,8 @@
 #define DP83822_RX_ER_SHIFT	8
 
 #define MII_DP83822_FIBER_ADVERTISE    (ADVERTISED_TP | ADVERTISED_MII | \
-					ADVERTISED_FIBRE | ADVERTISED_BNC |  \
-					ADVERTISED_Pause | ADVERTISED_Asym_Pause | \
-					ADVERTISED_100baseT_Full)
+					ADVERTISED_FIBRE | \
+					ADVERTISED_Pause | ADVERTISED_Asym_Pause)
 
 struct dp83822_private {
 	bool fx_signal_det_low;
@@ -406,6 +405,14 @@ static int dp83822_config_init(struct phy_device *phydev)
 				 phydev->supported);
 		linkmode_set_bit(ETHTOOL_LINK_MODE_FIBRE_BIT,
 				 phydev->advertising);
+		linkmode_set_bit(ETHTOOL_LINK_MODE_100baseFX_Full_BIT,
+				 phydev->supported);
+		linkmode_set_bit(ETHTOOL_LINK_MODE_100baseFX_Half_BIT,
+				 phydev->supported);
+		linkmode_set_bit(ETHTOOL_LINK_MODE_100baseFX_Full_BIT,
+				 phydev->advertising);
+		linkmode_set_bit(ETHTOOL_LINK_MODE_100baseFX_Half_BIT,
+				 phydev->advertising);
 
 		/* Auto neg is not supported in fiber mode */
 		bmcr = phy_read(phydev, MII_BMCR);