mmc: renesas_sdhi: use custom mask for TMIO_MASK_ALL

Populate the new member for custom mask values to make sure this value
is applied whenever needed. Also, rename the define holding the value
because this is not only about initialization anymore.
Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Reviewed-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
Tested-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
Link: https://lore.kernel.org/r/20210304092903.8534-1-wsa+renesas@sang-engineering.comSigned-off-by: Ulf Hansson <ulf.hansson@linaro.org>

drivers/mmc/host/renesas_sdhi_core.c

@@ -573,7 +573,7 @@ static void renesas_sdhi_reset(struct tmio_mmc_host *host)
 			       sd_scc_read32(host, priv, SH_MOBILE_SDHI_SCC_RVSCNTL));
 	}
 
-	sd_ctrl_write32_as_16_and_16(host, CTL_IRQ_MASK, TMIO_MASK_INIT_RCAR2);
+	sd_ctrl_write32_as_16_and_16(host, CTL_IRQ_MASK, TMIO_MASK_ALL_RCAR2);
 
 	if (sd_ctrl_read16(host, CTL_VERSION) >= SDHI_VER_GEN3_SD) {
 		val = sd_ctrl_read16(host, CTL_SD_MEM_CARD_OPT);
@@ -1034,6 +1034,7 @@ int renesas_sdhi_probe(struct platform_device *pdev,
 		host->ops.start_signal_voltage_switch =
 			renesas_sdhi_start_signal_voltage_switch;
 		host->sdcard_irq_setbit_mask = TMIO_STAT_ALWAYS_SET_27;
+		host->sdcard_irq_mask_all = TMIO_MASK_ALL_RCAR2;
 		host->reset = renesas_sdhi_reset;
 	}
 

drivers/mmc/host/tmio_mmc.h

@@ -100,8 +100,8 @@
 
 /* Define some IRQ masks */
 /* This is the mask used at reset by the chip */
-#define TMIO_MASK_INIT_RCAR2	0x8b7f031d /* Initial value for R-Car Gen2+ */
 #define TMIO_MASK_ALL           0x837f031d
+#define TMIO_MASK_ALL_RCAR2	0x8b7f031d
 #define TMIO_MASK_READOP  (TMIO_STAT_RXRDY | TMIO_STAT_DATAEND)
 #define TMIO_MASK_WRITEOP (TMIO_STAT_TXRQ | TMIO_STAT_DATAEND)
 #define TMIO_MASK_CMD     (TMIO_STAT_CMDRESPEND | TMIO_STAT_CMDTIMEOUT | \