thermal: exynos: Add driver support for exynos5440 TMU sensor

This patch modifies TMU controller to add changes needed to work with
exynos5440 platform. This sensor registers 3 instance of the tmu controller
with the thermal zone and hence reports 3 temperature output. This controller
supports upto five trip points. For critical threshold the driver uses the
core driver thermal framework for shutdown.
Acked-by: Jonghwa Lee <jonghwa3.lee@samsung.com>
Acked-by: Kukjin Kim <kgene.kim@samsung.com>
Signed-off-by: Jungseok Lee <jays.lee@samsung.com>
Signed-off-by: Amit Daniel Kachhap <amit.daniel@samsung.com>
Acked-by: Eduardo Valentin <eduardo.valentin@ti.com>
Signed-off-by: Eduardo Valentin <eduardo.valentin@ti.com>

drivers/thermal/samsung/exynos_thermal_common.h

@@ -27,7 +27,7 @@
 #define SENSOR_NAME_LEN	16
 #define MAX_TRIP_COUNT	8
 #define MAX_COOLING_DEVICE 4
-#define MAX_THRESHOLD_LEVS 4
+#define MAX_THRESHOLD_LEVS 5
 
 #define ACTIVE_INTERVAL 500
 #define IDLE_INTERVAL 10000

drivers/thermal/samsung/exynos_tmu.c

@@ -156,7 +156,26 @@ static int exynos_tmu_initialize(struct platform_device *pdev)
 		__raw_writel(1, data->base + reg->triminfo_ctrl);
 
 	/* Save trimming info in order to perform calibration */
-	trim_info = readl(data->base + reg->triminfo_data);
+	if (data->soc == SOC_ARCH_EXYNOS5440) {
+		/*
+		 * For exynos5440 soc triminfo value is swapped between TMU0 and
+		 * TMU2, so the below logic is needed.
+		 */
+		switch (data->id) {
+		case 0:
+			trim_info = readl(data->base +
+			EXYNOS5440_EFUSE_SWAP_OFFSET + reg->triminfo_data);
+			break;
+		case 1:
+			trim_info = readl(data->base + reg->triminfo_data);
+			break;
+		case 2:
+			trim_info = readl(data->base -
+			EXYNOS5440_EFUSE_SWAP_OFFSET + reg->triminfo_data);
+		}
+	} else {
+		trim_info = readl(data->base + reg->triminfo_data);
+	}
 	data->temp_error1 = trim_info & EXYNOS_TMU_TEMP_MASK;
 	data->temp_error2 = ((trim_info >> reg->triminfo_85_shift) &
 				EXYNOS_TMU_TEMP_MASK);
@@ -201,7 +220,7 @@ static int exynos_tmu_initialize(struct platform_device *pdev)
 			reg->threshold_th0 + i * sizeof(reg->threshold_th0));
 
 		writel(reg->inten_rise_mask, data->base + reg->tmu_intclear);
-	} else if (data->soc == SOC_ARCH_EXYNOS) {
+	} else {
 		/* Write temperature code for rising and falling threshold */
 		for (i = 0;
 		i < trigger_levs && i < EXYNOS_MAX_TRIGGER_PER_REG; i++) {
@@ -241,14 +260,26 @@ static int exynos_tmu_initialize(struct platform_device *pdev)
 				ret = threshold_code;
 				goto out;
 			}
-			rising_threshold |= threshold_code << 8 * i;
-			writel(rising_threshold,
-				data->base + reg->threshold_th0);
+			if (i == EXYNOS_MAX_TRIGGER_PER_REG - 1) {
+				/* 1-4 level to be assigned in th0 reg */
+				rising_threshold |= threshold_code << 8 * i;
+				writel(rising_threshold,
+					data->base + reg->threshold_th0);
+			} else if (i == EXYNOS_MAX_TRIGGER_PER_REG) {
+				/* 5th level to be assigned in th2 reg */
+				rising_threshold =
+				threshold_code << reg->threshold_th3_l0_shift;
+				writel(rising_threshold,
+					data->base + reg->threshold_th2);
+			}
 			con = readl(data->base + reg->tmu_ctrl);
 			con |= (1 << reg->therm_trip_en_shift);
 			writel(con, data->base + reg->tmu_ctrl);
 		}
 	}
+	/*Clear the PMIN in the common TMU register*/
+	if (reg->tmu_pmin && !data->id)
+		writel(0, data->base_common + reg->tmu_pmin);
 out:
 	clk_disable(data->clk);
 	mutex_unlock(&data->lock);
@@ -377,7 +408,14 @@ static void exynos_tmu_work(struct work_struct *work)
 			struct exynos_tmu_data, irq_work);
 	struct exynos_tmu_platform_data *pdata = data->pdata;
 	const struct exynos_tmu_registers *reg = pdata->registers;
-	unsigned int val_irq;
+	unsigned int val_irq, val_type;
+
+	/* Find which sensor generated this interrupt */
+	if (reg->tmu_irqstatus) {
+		val_type = readl(data->base_common + reg->tmu_irqstatus);
+		if (!((val_type >> data->id) & 0x1))
+			goto out;
+	}
 
 	exynos_report_trigger(data->reg_conf);
 	mutex_lock(&data->lock);
@@ -390,7 +428,7 @@ static void exynos_tmu_work(struct work_struct *work)
 
 	clk_disable(data->clk);
 	mutex_unlock(&data->lock);
-
+out:
 	enable_irq(data->irq);
 }
 
@@ -538,7 +576,8 @@ static int exynos_tmu_probe(struct platform_device *pdev)
 		return ret;
 
 	if (pdata->type == SOC_ARCH_EXYNOS ||
-				pdata->type == SOC_ARCH_EXYNOS4210)
+		pdata->type == SOC_ARCH_EXYNOS4210 ||
+				pdata->type == SOC_ARCH_EXYNOS5440)
 		data->soc = pdata->type;
 	else {
 		ret = -EINVAL;

drivers/thermal/samsung/exynos_tmu.h

@@ -40,6 +40,7 @@ enum calibration_mode {
 enum soc_type {
 	SOC_ARCH_EXYNOS4210 = 1,
 	SOC_ARCH_EXYNOS,
+	SOC_ARCH_EXYNOS5440,
 };
 
 /**
@@ -131,6 +132,8 @@ enum soc_type {
  * @emul_temp_shift: shift bits of emulation temperature.
  * @emul_time_shift: shift bits of emulation time.
  * @emul_time_mask: mask bits of emulation time.
+ * @tmu_irqstatus: register to find which TMU generated interrupts.
+ * @tmu_pmin: register to get/set the Pmin value.
  */
 struct exynos_tmu_registers {
 	u32	triminfo_data;
@@ -198,6 +201,9 @@ struct exynos_tmu_registers {
 	u32	emul_temp_shift;
 	u32	emul_time_shift;
 	u32	emul_time_mask;
+
+	u32	tmu_irqstatus;
+	u32	tmu_pmin;
 };
 
 /**

drivers/thermal/samsung/exynos_tmu_data.h

@@ -93,6 +93,42 @@
 
 #define EXYNOS_MAX_TRIGGER_PER_REG	4
 
+/*exynos5440 specific registers*/
+#define EXYNOS5440_TMU_S0_7_TRIM		0x000
+#define EXYNOS5440_TMU_S0_7_CTRL		0x020
+#define EXYNOS5440_TMU_S0_7_DEBUG		0x040
+#define EXYNOS5440_TMU_S0_7_STATUS		0x060
+#define EXYNOS5440_TMU_S0_7_TEMP		0x0f0
+#define EXYNOS5440_TMU_S0_7_TH0			0x110
+#define EXYNOS5440_TMU_S0_7_TH1			0x130
+#define EXYNOS5440_TMU_S0_7_TH2			0x150
+#define EXYNOS5440_TMU_S0_7_EVTEN		0x1F0
+#define EXYNOS5440_TMU_S0_7_IRQEN		0x210
+#define EXYNOS5440_TMU_S0_7_IRQ			0x230
+/* exynos5440 common registers */
+#define EXYNOS5440_TMU_IRQ_STATUS		0x000
+#define EXYNOS5440_TMU_PMIN			0x004
+#define EXYNOS5440_TMU_TEMP			0x008
+
+#define EXYNOS5440_TMU_RISE_INT_MASK		0xf
+#define EXYNOS5440_TMU_RISE_INT_SHIFT		0
+#define EXYNOS5440_TMU_FALL_INT_MASK		0xf
+#define EXYNOS5440_TMU_FALL_INT_SHIFT		4
+#define EXYNOS5440_TMU_INTEN_RISE0_SHIFT	0
+#define EXYNOS5440_TMU_INTEN_RISE1_SHIFT	1
+#define EXYNOS5440_TMU_INTEN_RISE2_SHIFT	2
+#define EXYNOS5440_TMU_INTEN_RISE3_SHIFT	3
+#define EXYNOS5440_TMU_INTEN_FALL0_SHIFT	4
+#define EXYNOS5440_TMU_INTEN_FALL1_SHIFT	5
+#define EXYNOS5440_TMU_INTEN_FALL2_SHIFT	6
+#define EXYNOS5440_TMU_INTEN_FALL3_SHIFT	7
+#define EXYNOS5440_TMU_TH_RISE0_SHIFT		0
+#define EXYNOS5440_TMU_TH_RISE1_SHIFT		8
+#define EXYNOS5440_TMU_TH_RISE2_SHIFT		16
+#define EXYNOS5440_TMU_TH_RISE3_SHIFT		24
+#define EXYNOS5440_TMU_TH_RISE4_SHIFT		24
+#define EXYNOS5440_EFUSE_SWAP_OFFSET		8
+
 #if defined(CONFIG_CPU_EXYNOS4210)
 extern struct exynos_tmu_init_data const exynos4210_default_tmu_data;
 #define EXYNOS4210_TMU_DRV_DATA (&exynos4210_default_tmu_data)