net: mscc: ocelot: fix incorrect balancing with down LAG ports
Assuming the test setup described here: https://patchwork.kernel.org/project/netdevbpf/cover/20210205130240.4072854-1-vladimir.oltean@nxp.com/ (swp1 and swp2 are in bond0, and bond0 is in a bridge with swp0) it can be seen that when swp1 goes down (on either board A or B), then traffic that should go through that port isn't forwarded anywhere. A dump of the PGID table shows the following: PGID_DST[0] = ports 0 PGID_DST[1] = ports 1 PGID_DST[2] = ports 2 PGID_DST[3] = ports 3 PGID_DST[4] = ports 4 PGID_DST[5] = ports 5 PGID_DST[6] = no ports PGID_AGGR[0] = ports 0, 1, 2, 3, 4, 5 PGID_AGGR[1] = ports 0, 1, 2, 3, 4, 5 PGID_AGGR[2] = ports 0, 1, 2, 3, 4, 5 PGID_AGGR[3] = ports 0, 1, 2, 3, 4, 5 PGID_AGGR[4] = ports 0, 1, 2, 3, 4, 5 PGID_AGGR[5] = ports 0, 1, 2, 3, 4, 5 PGID_AGGR[6] = ports 0, 1, 2, 3, 4, 5 PGID_AGGR[7] = ports 0, 1, 2, 3, 4, 5 PGID_AGGR[8] = ports 0, 1, 2, 3, 4, 5 PGID_AGGR[9] = ports 0, 1, 2, 3, 4, 5 PGID_AGGR[10] = ports 0, 1, 2, 3, 4, 5 PGID_AGGR[11] = ports 0, 1, 2, 3, 4, 5 PGID_AGGR[12] = ports 0, 1, 2, 3, 4, 5 PGID_AGGR[13] = ports 0, 1, 2, 3, 4, 5 PGID_AGGR[14] = ports 0, 1, 2, 3, 4, 5 PGID_AGGR[15] = ports 0, 1, 2, 3, 4, 5 PGID_SRC[0] = ports 1, 2 PGID_SRC[1] = ports 0 PGID_SRC[2] = ports 0 PGID_SRC[3] = no ports PGID_SRC[4] = no ports PGID_SRC[5] = no ports PGID_SRC[6] = ports 0, 1, 2, 3, 4, 5 Whereas a "good" PGID configuration for that setup should have looked like this: PGID_DST[0] = ports 0 PGID_DST[1] = ports 1, 2 PGID_DST[2] = ports 1, 2 PGID_DST[3] = ports 3 PGID_DST[4] = ports 4 PGID_DST[5] = ports 5 PGID_DST[6] = no ports PGID_AGGR[0] = ports 0, 2, 3, 4, 5 PGID_AGGR[1] = ports 0, 2, 3, 4, 5 PGID_AGGR[2] = ports 0, 2, 3, 4, 5 PGID_AGGR[3] = ports 0, 2, 3, 4, 5 PGID_AGGR[4] = ports 0, 2, 3, 4, 5 PGID_AGGR[5] = ports 0, 2, 3, 4, 5 PGID_AGGR[6] = ports 0, 2, 3, 4, 5 PGID_AGGR[7] = ports 0, 2, 3, 4, 5 PGID_AGGR[8] = ports 0, 2, 3, 4, 5 PGID_AGGR[9] = ports 0, 2, 3, 4, 5 PGID_AGGR[10] = ports 0, 2, 3, 4, 5 PGID_AGGR[11] = ports 0, 2, 3, 4, 5 PGID_AGGR[12] = ports 0, 2, 3, 4, 5 PGID_AGGR[13] = ports 0, 2, 3, 4, 5 PGID_AGGR[14] = ports 0, 2, 3, 4, 5 PGID_AGGR[15] = ports 0, 2, 3, 4, 5 PGID_SRC[0] = ports 1, 2 PGID_SRC[1] = ports 0 PGID_SRC[2] = ports 0 PGID_SRC[3] = no ports PGID_SRC[4] = no ports PGID_SRC[5] = no ports PGID_SRC[6] = ports 0, 1, 2, 3, 4, 5 In other words, in the "bad" configuration, the attempt is to remove the inactive swp1 from the destination ports via PGID_DST. But when a MAC table entry is learned, it is learned towards PGID_DST 1, because that is the logical port id of the LAG itself (it is equal to the lowest numbered member port). So when swp1 becomes inactive, if we set PGID_DST[1] to contain just swp1 and not swp2, the packet will not have any chance to reach the destination via swp2. The "correct" way to remove swp1 as a destination is via PGID_AGGR (remove swp1 from the aggregation port groups for all aggregation codes). This means that PGID_DST[1] and PGID_DST[2] must still contain both swp1 and swp2. This makes the MAC table still treat packets destined towards the single-port LAG as "multicast", and the inactive ports are removed via the aggregation code tables. The change presented here is a design one: the ocelot_get_bond_mask() function used to take an "only_active_ports" argument. We don't need that. The only call site that specifies only_active_ports=true, ocelot_set_aggr_pgids(), must retrieve the entire bonding mask, because it must program that into PGID_DST. Additionally, it must also clear the inactive ports from the bond mask here, which it can't do if bond_mask just contains the active ports: ac = ocelot_read_rix(ocelot, ANA_PGID_PGID, i); ac &= ~bond_mask; <---- here /* Don't do division by zero if there was no active * port. Just make all aggregation codes zero. */ if (num_active_ports) ac |= BIT(aggr_idx[i % num_active_ports]); ocelot_write_rix(ocelot, ac, ANA_PGID_PGID, i); So it becomes the responsibility of ocelot_set_aggr_pgids() to take ocelot_port->lag_tx_active into consideration when populating the aggr_idx array. Fixes: 23ca3b72 ("net: mscc: ocelot: rebalance LAGs on link up/down events") Signed-off-by:Vladimir Oltean <vladimir.oltean@nxp.com> Link: https://lore.kernel.org/r/20220107164332.402133-1-vladimir.oltean@nxp.comSigned-off-by:
Jakub Kicinski <kuba@kernel.org>
Showing
Please register or sign in to comment