ARM: dts: exynos: Enable WLAN support for the Trats board

Add a node for BCM4330/3 SDIO chip on SDHCI bus #3 and the required MMC
power sequence node for the Exynos4210-based Trats board.
Signed-off-by: Marek Szyprowski <m.szyprowski@samsung.com>
Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>

arch/arm/boot/dts/exynos4210-trats.dts

@@ -121,6 +121,11 @@ ok-key {
 		};
 	};
 
+	wlan_pwrseq: sdhci3-pwrseq {
+		compatible = "mmc-pwrseq-simple";
+		reset-gpios = <&gpl1 2 GPIO_ACTIVE_LOW>;
+	};
+
 	fixed-rate-clocks {
 		xxti {
 			compatible = "samsung,clock-xxti";
@@ -471,6 +476,30 @@ &sdhci_2 {
 	status = "okay";
 };
 
+&sdhci_3 {
+	status = "okay";
+
+	#address-cells = <1>;
+	#size-cells = <0>;
+
+	non-removable;
+	bus-width = <4>;
+	mmc-pwrseq = <&wlan_pwrseq>;
+	vmmc-supply = <&tflash_reg>;
+
+	pinctrl-names = "default";
+	pinctrl-0 = <&sd3_clk>, <&sd3_cmd>, <&sd3_bus4>;
+
+	brcmf: wifi@1 {
+		compatible = "brcm,bcm4330-fmac";
+		reg = <1>;
+
+		interrupt-parent = <&gpx2>;
+		interrupts = <5 IRQ_TYPE_LEVEL_HIGH>;
+		interrupt-names = "host-wake";
+	};
+};
+
 &serial_0 {
 	status = "okay";
 };