brcmfmac: don't realloc wiphy during PCIe reset

Providing a new wiphy on every PCIe reset was confusing and was causing
configuration problems for some users (supplicant and authenticators).
Sticking to the existing wiphy should make error recovery much simpler
and more reliable.
Signed-off-by: Rafał Miłecki <rafal@milecki.pl>
Acked-by: Arend van Spriel <arend.vanspriel@broadcom.com>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>

drivers/net/wireless/broadcom/brcm80211/brcmfmac/pcie.c

@@ -1430,7 +1430,6 @@ static int brcmf_pcie_reset(struct device *dev)
 	brcmf_pcie_bus_console_read(devinfo, true);
 
 	brcmf_detach(dev);
-	brcmf_free(dev);
 
 	brcmf_pcie_release_irq(devinfo);
 	brcmf_pcie_release_scratchbuffers(devinfo);
@@ -1826,9 +1825,6 @@ static void brcmf_pcie_setup(struct device *dev, int ret,
 	brcmf_pcie_intr_enable(devinfo);
 	brcmf_pcie_hostready(devinfo);
 
-	ret = brcmf_alloc(&devinfo->pdev->dev, devinfo->settings);
-	if (ret)
-		goto fail;
 	ret = brcmf_attach(&devinfo->pdev->dev);
 	if (ret)
 		goto fail;
@@ -1931,6 +1927,10 @@ brcmf_pcie_probe(struct pci_dev *pdev, const struct pci_device_id *id)
 	bus->wowl_supported = pci_pme_capable(pdev, PCI_D3hot);
 	dev_set_drvdata(&pdev->dev, bus);
 
+	ret = brcmf_alloc(&devinfo->pdev->dev, devinfo->settings);
+	if (ret)
+		goto fail_bus;
+
 	fwreq = brcmf_pcie_prepare_fw_request(devinfo);
 	if (!fwreq) {
 		ret = -ENOMEM;