gpio: vf610: Simplify vf610_gpio_set()

The only difference between two codepaths is register offset
used. Simplify the code a bit by replacing explicit calls with a
single call with a variable offset. No functional change intended.
Signed-off-by: Andrey Smirnov <andrew.smirnov@gmail.com>
Cc: Linus Walleij <linus.walleij@linaro.org>
Cc: Bartosz Golaszewski <bgolaszewski@baylibre.com>
Cc: Chris Healy <cphealy@gmail.com>
Cc: Andrew Lunn <andrew@lunn.ch>
Cc: Heiner Kallweit <hkallweit1@gmail.com>
Cc: Fabio Estevam <festevam@gmail.com>
Cc: linux-gpio@vger.kernel.org
Cc: linux-kernel@vger.kernel.org
Cc: linux-imx@nxp.com
Signed-off-by: Bartosz Golaszewski <bgolaszewski@baylibre.com>

drivers/gpio/gpio-vf610.c

@@ -102,11 +102,9 @@ static void vf610_gpio_set(struct gpio_chip *gc, unsigned int gpio, int val)
 {
 	struct vf610_gpio_port *port = gpiochip_get_data(gc);
 	unsigned long mask = BIT(gpio);
+	unsigned long offset = val ? GPIO_PSOR : GPIO_PCOR;
 
-	if (val)
-		vf610_gpio_writel(mask, port->gpio_base + GPIO_PSOR);
-	else
-		vf610_gpio_writel(mask, port->gpio_base + GPIO_PCOR);
+	vf610_gpio_writel(mask, port->gpio_base + offset);
 }
 
 static int vf610_gpio_direction_input(struct gpio_chip *chip, unsigned gpio)