Commit a3e17eb8 authored by Zhao Yakui's avatar Zhao Yakui Committed by Eric Anholt

drm/i915: Set the LVDS_BORDER when using LVDS scaling mode

According to the spec the LVDS_BORDER_ENABLE bit decides whether the border
data should be included in the active display and data sent to the panel.
Border should be used when in VGA centered (un-scaled) mode or when scaling
a 4:3 source image to a wide screen panel (typical 16:9).

So when the LVDS scaling is used, decide whether the LVDS_BORDER should be
enabled or not according to the current scaling mode.

At the same time fix the typo error in LVDS center scaling mode.

https://bugs.freedesktop.org/show_bug.cgi?id=23789Signed-off-by: default avatarZhao Yakui <yakui.zhao@intel.com>
tested-by: default avatarZhao Jian <jian.zhao@intel.com>
Signed-off-by: default avatarEric Anholt <eric@anholt.net>
parent 9216d44d
......@@ -492,6 +492,8 @@ typedef struct drm_i915_private {
struct drm_i915_gem_phys_object *phys_objs[I915_MAX_PHYS_OBJECT];
} mm;
struct sdvo_device_mapping sdvo_mappings[2];
/* indicate whether the LVDS_BORDER should be enabled or not */
unsigned int lvds_border_bits;
/* Reclocking support */
bool render_reclock_avail;
......
......@@ -968,6 +968,8 @@
#define LVDS_PORT_EN (1 << 31)
/* Selects pipe B for LVDS data. Must be set on pre-965. */
#define LVDS_PIPEB_SELECT (1 << 30)
/* Enable border for unscaled (or aspect-scaled) display */
#define LVDS_BORDER_ENABLE (1 << 15)
/*
* Enables the A0-A2 data pairs and CLKA, containing 18 bits of color data per
* pixel.
......
......@@ -2936,6 +2936,8 @@ static int intel_crtc_mode_set(struct drm_crtc *crtc,
lvds = I915_READ(lvds_reg);
lvds |= LVDS_PORT_EN | LVDS_A0A2_CLKA_POWER_UP | LVDS_PIPEB_SELECT;
/* set the corresponsding LVDS_BORDER bit */
lvds |= dev_priv->lvds_border_bits;
/* Set the B0-B3 data pairs corresponding to whether we're going to
* set the DPLLs for dual-channel mode or not.
*/
......
......@@ -380,7 +380,7 @@ static bool intel_lvds_mode_fixup(struct drm_encoder *encoder,
adjusted_mode->crtc_vblank_start + vsync_pos;
/* keep the vsync width constant */
adjusted_mode->crtc_vsync_end =
adjusted_mode->crtc_vblank_start + vsync_width;
adjusted_mode->crtc_vsync_start + vsync_width;
border = 1;
break;
case DRM_MODE_SCALE_ASPECT:
......@@ -525,6 +525,14 @@ static bool intel_lvds_mode_fixup(struct drm_encoder *encoder,
out:
lvds_priv->pfit_control = pfit_control;
lvds_priv->pfit_pgm_ratios = pfit_pgm_ratios;
/*
* When there exists the border, it means that the LVDS_BORDR
* should be enabled.
*/
if (border)
dev_priv->lvds_border_bits |= LVDS_BORDER_ENABLE;
else
dev_priv->lvds_border_bits &= ~(LVDS_BORDER_ENABLE);
/*
* XXX: It would be nice to support lower refresh rates on the
* panels to reduce power consumption, and perhaps match the
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment