ASoC: Intel: atom: enable configuration of SSP0

Existing code used SSP2, make selection of SSP id
dependent on port name. This is required when the
machine driver uses non-default settings
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

sound/soc/intel/atom/sst-atom-controls.c

@@ -935,17 +935,26 @@ void sst_fill_ssp_defaults(struct snd_soc_dai *dai)
 int send_ssp_cmd(struct snd_soc_dai *dai, const char *id, bool enable)
 {
 	struct sst_data *drv = snd_soc_dai_get_drvdata(dai);
-	const struct sst_ssp_config *config;
+	int ssp_id;
 
 	dev_info(dai->dev, "Enter: enable=%d port_name=%s\n", enable, id);
 
+	if (strcmp(id, "ssp0-port") == 0)
+		ssp_id = SSP_MODEM;
+	else if (strcmp(id, "ssp2-port") == 0)
+		ssp_id = SSP_CODEC;
+	else {
+		dev_dbg(dai->dev, "port %s is not supported\n", id);
+		return -1;
+	}
+
 	SST_FILL_DEFAULT_DESTINATION(drv->ssp_cmd.header.dst);
 	drv->ssp_cmd.header.command_id = SBA_HW_SET_SSP;
 	drv->ssp_cmd.header.length = sizeof(struct sst_cmd_sba_hw_set_ssp)
 				- sizeof(struct sst_dsp_header);
 
-	config = &sst_ssp_configs;
-	dev_dbg(dai->dev, "ssp_id: %u\n", config->ssp_id);
+	drv->ssp_cmd.selection = ssp_id;
+	dev_dbg(dai->dev, "ssp_id: %u\n", ssp_id);
 
 	if (enable)
 		drv->ssp_cmd.switch_state = SST_SWITCH_ON;