ath10k: re-disable interrupts after target init

If MSI isn't configured device ROM program expects
legacy interrupts to be enabled before it can
fully boot. Don't forget to disable legacy
interrupts after that.

While at it re-use the legacy irq enabling helper
instead of calling ath10k_pci_write32().
Signed-off-by: Michal Kazior <michal.kazior@tieto.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>

drivers/net/wireless/ath/ath10k/pci.c

@@ -2279,14 +2279,13 @@ static int ath10k_pci_wait_for_target_init(struct ath10k *ar)
 
 		if (ar_pci->num_msi_intrs == 0)
 			/* Fix potential race by repeating CORE_BASE writes */
-			ath10k_pci_write32(ar, SOC_CORE_BASE_ADDRESS +
-					   PCIE_INTR_ENABLE_ADDRESS,
-					   PCIE_INTR_FIRMWARE_MASK |
-					   PCIE_INTR_CE_MASK_ALL);
+			ath10k_pci_enable_legacy_irq(ar);
 
 		mdelay(10);
 	} while (time_before(jiffies, timeout));
 
+	ath10k_pci_disable_and_clear_legacy_irq(ar);
+
 	if (val == 0xffffffff) {
 		ath10k_err(ar, "failed to read device register, device is gone\n");
 		return -EIO;