Commit a504e64a authored by Stephen Hemminger's avatar Stephen Hemminger Committed by Jeff Garzik

skge: WOL support

Add WOL support for Yukon chipsets in skge device.
Signed-off-by: default avatarStephen Hemminger <shemminger@linux-foundation.org>
Signed-off-by: default avatarJeff Garzik <jeff@garzik.org>
parent 1479d13c
......@@ -132,18 +132,93 @@ static void skge_get_regs(struct net_device *dev, struct ethtool_regs *regs,
}
/* Wake on Lan only supported on Yukon chips with rev 1 or above */
static int wol_supported(const struct skge_hw *hw)
static u32 wol_supported(const struct skge_hw *hw)
{
return !((hw->chip_id == CHIP_ID_GENESIS ||
(hw->chip_id == CHIP_ID_YUKON && hw->chip_rev == 0)));
if (hw->chip_id == CHIP_ID_YUKON && hw->chip_rev != 0)
return WAKE_MAGIC | WAKE_PHY;
else
return 0;
}
static u32 pci_wake_enabled(struct pci_dev *dev)
{
int pm = pci_find_capability(dev, PCI_CAP_ID_PM);
u16 value;
/* If device doesn't support PM Capabilities, but request is to disable
* wake events, it's a nop; otherwise fail */
if (!pm)
return 0;
pci_read_config_word(dev, pm + PCI_PM_PMC, &value);
value &= PCI_PM_CAP_PME_MASK;
value >>= ffs(PCI_PM_CAP_PME_MASK) - 1; /* First bit of mask */
return value != 0;
}
static void skge_wol_init(struct skge_port *skge)
{
struct skge_hw *hw = skge->hw;
int port = skge->port;
enum pause_control save_mode;
u32 ctrl;
/* Bring hardware out of reset */
skge_write16(hw, B0_CTST, CS_RST_CLR);
skge_write16(hw, SK_REG(port, GMAC_LINK_CTRL), GMLC_RST_CLR);
skge_write8(hw, SK_REG(port, GPHY_CTRL), GPC_RST_CLR);
skge_write8(hw, SK_REG(port, GMAC_CTRL), GMC_RST_CLR);
/* Force to 10/100 skge_reset will re-enable on resume */
save_mode = skge->flow_control;
skge->flow_control = FLOW_MODE_SYMMETRIC;
ctrl = skge->advertising;
skge->advertising &= ~(ADVERTISED_1000baseT_Half|ADVERTISED_1000baseT_Full);
skge_phy_reset(skge);
skge->flow_control = save_mode;
skge->advertising = ctrl;
/* Set GMAC to no flow control and auto update for speed/duplex */
gma_write16(hw, port, GM_GP_CTRL,
GM_GPCR_FC_TX_DIS|GM_GPCR_TX_ENA|GM_GPCR_RX_ENA|
GM_GPCR_DUP_FULL|GM_GPCR_FC_RX_DIS|GM_GPCR_AU_FCT_DIS);
/* Set WOL address */
memcpy_toio(hw->regs + WOL_REGS(port, WOL_MAC_ADDR),
skge->netdev->dev_addr, ETH_ALEN);
/* Turn on appropriate WOL control bits */
skge_write16(hw, WOL_REGS(port, WOL_CTRL_STAT), WOL_CTL_CLEAR_RESULT);
ctrl = 0;
if (skge->wol & WAKE_PHY)
ctrl |= WOL_CTL_ENA_PME_ON_LINK_CHG|WOL_CTL_ENA_LINK_CHG_UNIT;
else
ctrl |= WOL_CTL_DIS_PME_ON_LINK_CHG|WOL_CTL_DIS_LINK_CHG_UNIT;
if (skge->wol & WAKE_MAGIC)
ctrl |= WOL_CTL_ENA_PME_ON_MAGIC_PKT|WOL_CTL_ENA_MAGIC_PKT_UNIT;
else
ctrl |= WOL_CTL_DIS_PME_ON_MAGIC_PKT|WOL_CTL_DIS_MAGIC_PKT_UNIT;;
ctrl |= WOL_CTL_DIS_PME_ON_PATTERN|WOL_CTL_DIS_PATTERN_UNIT;
skge_write16(hw, WOL_REGS(port, WOL_CTRL_STAT), ctrl);
/* block receiver */
skge_write8(hw, SK_REG(port, RX_GMF_CTRL_T), GMF_RST_SET);
}
static void skge_get_wol(struct net_device *dev, struct ethtool_wolinfo *wol)
{
struct skge_port *skge = netdev_priv(dev);
wol->supported = wol_supported(skge->hw) ? WAKE_MAGIC : 0;
wol->wolopts = skge->wol ? WAKE_MAGIC : 0;
wol->supported = wol_supported(skge->hw);
wol->wolopts = skge->wol;
}
static int skge_set_wol(struct net_device *dev, struct ethtool_wolinfo *wol)
......@@ -151,23 +226,12 @@ static int skge_set_wol(struct net_device *dev, struct ethtool_wolinfo *wol)
struct skge_port *skge = netdev_priv(dev);
struct skge_hw *hw = skge->hw;
if (wol->wolopts != WAKE_MAGIC && wol->wolopts != 0)
return -EOPNOTSUPP;
if (wol->wolopts == WAKE_MAGIC && !wol_supported(hw))
if (wol->wolopts & wol_supported(hw))
return -EOPNOTSUPP;
skge->wol = wol->wolopts == WAKE_MAGIC;
if (skge->wol) {
memcpy_toio(hw->regs + WOL_MAC_ADDR, dev->dev_addr, ETH_ALEN);
skge_write16(hw, WOL_CTRL_STAT,
WOL_CTL_ENA_PME_ON_MAGIC_PKT |
WOL_CTL_ENA_MAGIC_PKT_UNIT);
} else
skge_write16(hw, WOL_CTRL_STAT, WOL_CTL_DEFAULT);
skge->wol = wol->wolopts;
if (!netif_running(dev))
skge_wol_init(skge);
return 0;
}
......@@ -3456,6 +3520,7 @@ static struct net_device *skge_devinit(struct skge_hw *hw, int port,
skge->duplex = -1;
skge->speed = -1;
skge->advertising = skge_supported_modes(hw);
skge->wol = pci_wake_enabled(hw->pdev) ? wol_supported(hw) : 0;
hw->dev[port] = dev;
......@@ -3654,28 +3719,46 @@ static void __devexit skge_remove(struct pci_dev *pdev)
}
#ifdef CONFIG_PM
static int vaux_avail(struct pci_dev *pdev)
{
int pm_cap;
pm_cap = pci_find_capability(pdev, PCI_CAP_ID_PM);
if (pm_cap) {
u16 ctl;
pci_read_config_word(pdev, pm_cap + PCI_PM_PMC, &ctl);
if (ctl & PCI_PM_CAP_AUX_POWER)
return 1;
}
return 0;
}
static int skge_suspend(struct pci_dev *pdev, pm_message_t state)
{
struct skge_hw *hw = pci_get_drvdata(pdev);
int i, wol = 0;
int i, err, wol = 0;
err = pci_save_state(pdev);
if (err)
return err;
pci_save_state(pdev);
for (i = 0; i < hw->ports; i++) {
struct net_device *dev = hw->dev[i];
struct skge_port *skge = netdev_priv(dev);
if (netif_running(dev)) {
struct skge_port *skge = netdev_priv(dev);
if (netif_running(dev))
skge_down(dev);
if (skge->wol)
skge_wol_init(skge);
netif_carrier_off(dev);
if (skge->wol)
netif_stop_queue(dev);
else
skge_down(dev);
wol |= skge->wol;
}
netif_device_detach(dev);
wol |= skge->wol;
}
if (wol && vaux_avail(pdev))
skge_write8(hw, B0_POWER_CTRL,
PC_VAUX_ENA | PC_VCC_ENA | PC_VAUX_ON | PC_VCC_OFF);
skge_write32(hw, B0_IMSK, 0);
pci_enable_wake(pdev, pci_choose_state(pdev, state), wol);
pci_set_power_state(pdev, pci_choose_state(pdev, state));
......@@ -3688,8 +3771,14 @@ static int skge_resume(struct pci_dev *pdev)
struct skge_hw *hw = pci_get_drvdata(pdev);
int i, err;
pci_set_power_state(pdev, PCI_D0);
pci_restore_state(pdev);
err = pci_set_power_state(pdev, PCI_D0);
if (err)
goto out;
err = pci_restore_state(pdev);
if (err)
goto out;
pci_enable_wake(pdev, PCI_D0, 0);
err = skge_reset(hw);
......@@ -3699,7 +3788,6 @@ static int skge_resume(struct pci_dev *pdev)
for (i = 0; i < hw->ports; i++) {
struct net_device *dev = hw->dev[i];
netif_device_attach(dev);
if (netif_running(dev)) {
err = skge_up(dev);
......
......@@ -876,11 +876,13 @@ enum {
WOL_PATT_CNT_0 = 0x0f38,/* 32 bit WOL Pattern Counter 3..0 */
WOL_PATT_CNT_4 = 0x0f3c,/* 24 bit WOL Pattern Counter 6..4 */
};
#define WOL_REGS(port, x) (x + (port)*0x80)
enum {
WOL_PATT_RAM_1 = 0x1000,/* WOL Pattern RAM Link 1 */
WOL_PATT_RAM_2 = 0x1400,/* WOL Pattern RAM Link 2 */
};
#define WOL_PATT_RAM_BASE(port) (WOL_PATT_RAM_1 + (port)*0x400)
enum {
BASE_XMAC_1 = 0x2000,/* XMAC 1 registers */
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment