Commit a6214218 authored by Dong Aisheng's avatar Dong Aisheng Committed by Linus Walleij

dt-bindings: pinctrl: add imx7ulp pinctrl binding doc

i.MX 7ULP has three IOMUXC instances: IOMUXC0 for M4 ports,
IOMUXC1 for A7 ports and IOMUXC DDR for DDR interface.

This patch adds the IOMUXC1 support for A7.

Cc: Mark Rutland <mark.rutland@arm.com>
Cc: devicetree@vger.kernel.org
Acked-by: default avatarRob Herring <robh@kernel.org>
Acked-by: default avatarShawn Guo <shawnguo@kernel.org>
Signed-off-by: default avatarDong Aisheng <aisheng.dong@nxp.com>
Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
parent c3ed6f48
* Freescale i.MX7ULP IOMUX Controller
i.MX 7ULP has three IOMUXC instances: IOMUXC0 for M4 ports, IOMUXC1 for A7
ports and IOMUXC DDR for DDR interface.
Note:
This binding doc is only for the IOMUXC1 support in A7 Domain and it only
supports generic pin config.
Please also refer pinctrl-bindings.txt in this directory for generic pinctrl
binding.
=== Pin Controller Node ===
Required properties:
- compatible: "fsl,imx7ulp-iomuxc1"
- reg: Should contain the base physical address and size of the iomuxc
registers.
=== Pin Configuration Node ===
- pinmux: One integers array, represents a group of pins mux setting.
The format is pinmux = <PIN_FUNC_ID>, PIN_FUNC_ID is a pin working on
a specific function.
NOTE: i.MX7ULP PIN_FUNC_ID consists of 4 integers as it shares one mux
and config register as follows:
<mux_conf_reg input_reg mux_mode input_val>
Refer to imx7ulp-pinfunc.h in in device tree source folder for all
available imx7ulp PIN_FUNC_ID.
Optional Properties:
- drive-strength Integer. Controls Drive Strength
0: Standard
1: Hi Driver
- drive-push-pull Bool. Enable Pin Push-pull
- drive-open-drain Bool. Enable Pin Open-drian
- slew-rate: Integer. Controls Slew Rate
0: Standard
1: Slow
- bias-disable: Bool. Pull disabled
- bias-pull-down: Bool. Pull down on pin
- bias-pull-up: Bool. Pull up on pin
Examples:
#include "imx7ulp-pinfunc.h"
/* Pin Controller Node */
iomuxc1: iomuxc@40ac0000 {
compatible = "fsl,imx7ulp-iomuxc1";
reg = <0x40ac0000 0x1000>;
/* Pin Configuration Node */
pinctrl_lpuart4: lpuart4grp {
pinmux = <
IMX7ULP_PAD_PTC3__LPUART4_RX
IMX7ULP_PAD_PTC2__LPUART4_TX
>;
bias-pull-up;
};
};
This diff is collapsed.
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment