atmel_serial: add DMA support

This patch is based on the DMA-patch by Chip Coldwell for the AT91/AT32 serial
USARTS, with some tweaks to make it apply neatly on top of the other patches
in this series.

The RX and TX code has been moved to a tasklet and reworked a bit.  Instead of
depending on the ENDRX and TIMEOUT bits in CSR, we simply grab as much data as
we can from the DMA buffers.  I think this closes a race where the ENDRX bit
is set after we read CSR but before we read RPR, although I haven't confirmed
this.

Similarly, the two TX handlers (ENDTX and TXBUFE) have been combined into one.
 Since the current code only uses a single TX buffer, there's no point in
handling those interrupts separately.

This also fixes a DMA sync bug in the original patch.

[linux@bohmer.net: rebased onto irq-splitup patch]
[hskinnemoen@atmel.com: moved to tasklet, fixed dma bug, misc cleanups]
[hskinnemoen@atmel.com: atmel_serial dma: Misc fixes and cleanups]
Signed-off-by: Remy Bohmer <linux@bohmer.net>
Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
Cc: Andrew Victor <linux@maxim.org.za>
Tested-by: Marc Pignat <marc.pignat@hevs.ch>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

drivers/serial/Kconfig

@@ -380,6 +380,21 @@ config SERIAL_ATMEL_CONSOLE
 	  console is the device which receives all kernel messages and
 	  warnings and which allows logins in single user mode).
 
+config SERIAL_ATMEL_PDC
+	bool "Support DMA transfers on AT91 / AT32 serial port"
+	depends on SERIAL_ATMEL
+	default y
+	help
+	  Say Y here if you wish to use the PDC to do DMA transfers to
+	  and from the Atmel AT91 / AT32 serial port. In order to
+	  actually use DMA transfers, make sure that the use_dma_tx
+	  and use_dma_rx members in the atmel_uart_data struct is set
+	  appropriately for each port.
+
+	  Note that break and error handling currently doesn't work
+	  properly when DMA is enabled. Make sure that ports where
+	  this matters don't use DMA.
+
 config SERIAL_ATMEL_TTYAT
 	bool "Install as device ttyATn instead of ttySn"
 	depends on SERIAL_ATMEL=y