dt-bindings: add documentation for rk1108 cru

This adds the dt-binding documentation for the clock and reset unit
found on Rockchip rk1108 SoCs.
Signed-off-by: Shawn Lin <shawn.lin@rock-chips.com>
Signed-off-by: Heiko Stuebner <heiko@sntech.de>

Documentation/devicetree/bindings/clock/rockchip,rk1108-cru.txt

+* Rockchip RK1108 Clock and Reset Unit
+
+The RK1108 clock controller generates and supplies clock to various
+controllers within the SoC and also implements a reset controller for SoC
+peripherals.
+
+Required Properties:
+
+- compatible: should be "rockchip,rk1108-cru"
+- reg: physical base address of the controller and length of memory mapped
+  region.
+- #clock-cells: should be 1.
+- #reset-cells: should be 1.
+
+Optional Properties:
+
+- rockchip,grf: phandle to the syscon managing the "general register files"
+  If missing pll rates are not changeable, due to the missing pll lock status.
+
+Each clock is assigned an identifier and client nodes can use this identifier
+to specify the clock which they consume. All available clocks are defined as
+preprocessor macros in the dt-bindings/clock/rk1108-cru.h headers and can be
+used in device tree sources. Similar macros exist for the reset sources in
+these files.
+
+External clocks:
+
+There are several clocks that are generated outside the SoC. It is expected
+that they are defined using standard clock bindings with following
+clock-output-names:
+ - "xin24m" - crystal input - required,
+ - "ext_vip" - external VIP clock - optional
+ - "ext_i2s" - external I2S clock - optional
+ - "ext_gmac" - external GMAC clock - optional
+ - "hdmiphy" - external clock input derived from HDMI PHY - optional
+ - "usbphy" - external clock input derived from USB PHY - optional
+
+Example: Clock controller node:
+
+	cru: cru@20200000 {
+		compatible = "rockchip,rk1108-cru";
+		reg = <0x20200000 0x1000>;
+		rockchip,grf = <&grf>;
+
+		#clock-cells = <1>;
+		#reset-cells = <1>;
+	};
+
+Example: UART controller node that consumes the clock generated by the clock
+  controller:
+
+	uart0: serial@10230000 {
+		compatible = "rockchip,rk1108-uart", "snps,dw-apb-uart";
+		reg = <0x10230000 0x100>;
+		interrupts = <GIC_SPI 44 IRQ_TYPE_LEVEL_HIGH>;
+		reg-shift = <2>;
+		reg-io-width = <4>;
+		clocks = <&cru SCLK_UART0>;
+	};