Commit acc8b8e1 authored by Alexandre Belloni's avatar Alexandre Belloni Committed by Nicolas Ferre

ARM: at91: sam9260: remove unused platform_data

num_channels and registers are not used anymore since they are defined inside
the at91_adc driver and assigned by matching the id_table.

Also, remove the mach/at91_adc.h include that is not necessary anymore.
Signed-off-by: default avatarAlexandre Belloni <alexandre.belloni@free-electrons.com>
Acked-by: default avatarJonathan Cameron <jic23@kernel.org>
Signed-off-by: default avatarNicolas Ferre <nicolas.ferre@atmel.com>
parent 616a28ed
...@@ -24,7 +24,6 @@ ...@@ -24,7 +24,6 @@
#include <mach/at91sam9260_matrix.h> #include <mach/at91sam9260_matrix.h>
#include <mach/at91_matrix.h> #include <mach/at91_matrix.h>
#include <mach/at91sam9_smc.h> #include <mach/at91sam9_smc.h>
#include <mach/at91_adc.h>
#include <mach/hardware.h> #include <mach/hardware.h>
#include "board.h" #include "board.h"
...@@ -1325,13 +1324,6 @@ static struct at91_adc_trigger at91_adc_triggers[] = { ...@@ -1325,13 +1324,6 @@ static struct at91_adc_trigger at91_adc_triggers[] = {
}, },
}; };
static struct at91_adc_reg_desc at91_adc_register_g20 = {
.channel_base = AT91_ADC_CHR(0),
.drdy_mask = AT91_ADC_DRDY,
.status_register = AT91_ADC_SR,
.trigger_register = AT91_ADC_MR,
};
void __init at91_add_device_adc(struct at91_adc_data *data) void __init at91_add_device_adc(struct at91_adc_data *data)
{ {
if (!data) if (!data)
...@@ -1349,9 +1341,7 @@ void __init at91_add_device_adc(struct at91_adc_data *data) ...@@ -1349,9 +1341,7 @@ void __init at91_add_device_adc(struct at91_adc_data *data)
if (data->use_external_triggers) if (data->use_external_triggers)
at91_set_A_periph(AT91_PIN_PA22, 0); at91_set_A_periph(AT91_PIN_PA22, 0);
data->num_channels = 4;
data->startup_time = 10; data->startup_time = 10;
data->registers = &at91_adc_register_g20;
data->trigger_number = 4; data->trigger_number = 4;
data->trigger_list = at91_adc_triggers; data->trigger_list = at91_adc_triggers;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment