mt76x0: use band parameter for LC calibration

We use always 1 as band parameter for MCU_CAL_LC, this break 2GHz,
we should use 0 for this band instead.

Patch fixes problems happened sometimes when try to associate with 2GHz
AP and manifest by errors like below:

[14680.920823] wlan0: authenticate with 18:31:bf:c0:51:b0
[14681.109506] wlan0: send auth to 18:31:bf:c0:51:b0 (try 1/3)
[14681.310454] wlan0: send auth to 18:31:bf:c0:51:b0 (try 2/3)
[14681.518469] wlan0: send auth to 18:31:bf:c0:51:b0 (try 3/3)
[14681.726499] wlan0: authentication with 18:31:bf:c0:51:b0 timed out

Fixes: 9aec146d ("mt76x0: pci: introduce mt76x0_phy_calirate routine")
Signed-off-by: Stanislaw Gruszka <sgruszka@redhat.com>
Signed-off-by: Felix Fietkau <nbd@nbd.name>

drivers/net/wireless/mediatek/mt76/mt76x0/phy.c

@@ -861,6 +861,7 @@ void mt76x0_phy_set_txpower(struct mt76x02_dev *dev)
 void mt76x0_phy_calibrate(struct mt76x02_dev *dev, bool power_on)
 {
 	struct ieee80211_channel *chan = dev->mt76.chandef.chan;
+	int is_5ghz = (chan->band == NL80211_BAND_5GHZ) ? 1 : 0;
 	u32 val, tx_alc, reg_val;
 
 	if (is_mt7630(dev))
@@ -889,7 +890,7 @@ void mt76x0_phy_calibrate(struct mt76x02_dev *dev, bool power_on)
 	reg_val = mt76_rr(dev, MT_BBP(IBI, 9));
 	mt76_wr(dev, MT_BBP(IBI, 9), 0xffffff7e);
 
-	if (chan->band == NL80211_BAND_5GHZ) {
+	if (is_5ghz) {
 		if (chan->hw_value < 100)
 			val = 0x701;
 		else if (chan->hw_value < 140)
@@ -902,7 +903,7 @@ void mt76x0_phy_calibrate(struct mt76x02_dev *dev, bool power_on)
 
 	mt76x02_mcu_calibrate(dev, MCU_CAL_FULL, val, false);
 	msleep(350);
-	mt76x02_mcu_calibrate(dev, MCU_CAL_LC, 1, false);
+	mt76x02_mcu_calibrate(dev, MCU_CAL_LC, is_5ghz, false);
 	usleep_range(15000, 20000);
 
 	mt76_wr(dev, MT_BBP(IBI, 9), reg_val);