stmmac: fix PHY reset during resume

When stmmac_mdio_reset, was called from stmmac_resume, it was not
resetting the PHY due to which MAC was not getting reset properly and
hence ethernet interface not was resumed properly.
The issue was currently only reproducible on stih301-b2204.
Signed-off-by: Pankaj Dev <pankaj.dev@st.com>
Signed-off-by: Giuseppe Cavallaro <peppe.cavallaro@st.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c

@@ -138,7 +138,6 @@ int stmmac_mdio_reset(struct mii_bus *bus)
 
 #ifdef CONFIG_OF
 	if (priv->device->of_node) {
-		int reset_gpio, active_low;
 
 		if (data->reset_gpio < 0) {
 			struct device_node *np = priv->device->of_node;
@@ -154,24 +153,23 @@ int stmmac_mdio_reset(struct mii_bus *bus)
 						"snps,reset-active-low");
 			of_property_read_u32_array(np,
 				"snps,reset-delays-us", data->delays, 3);
-		}
 
-		reset_gpio = data->reset_gpio;
-		active_low = data->active_low;
+			if (gpio_request(data->reset_gpio, "mdio-reset"))
+				return 0;
+		}
 
-		if (!gpio_request(reset_gpio, "mdio-reset")) {
-			gpio_direction_output(reset_gpio, active_low ? 1 : 0);
-			if (data->delays[0])
-				msleep(DIV_ROUND_UP(data->delays[0], 1000));
+		gpio_direction_output(data->reset_gpio,
+				      data->active_low ? 1 : 0);
+		if (data->delays[0])
+			msleep(DIV_ROUND_UP(data->delays[0], 1000));
 
-			gpio_set_value(reset_gpio, active_low ? 0 : 1);
-			if (data->delays[1])
-				msleep(DIV_ROUND_UP(data->delays[1], 1000));
+		gpio_set_value(data->reset_gpio, data->active_low ? 0 : 1);
+		if (data->delays[1])
+			msleep(DIV_ROUND_UP(data->delays[1], 1000));
 
-			gpio_set_value(reset_gpio, active_low ? 1 : 0);
-			if (data->delays[2])
-				msleep(DIV_ROUND_UP(data->delays[2], 1000));
-		}
+		gpio_set_value(data->reset_gpio, data->active_low ? 1 : 0);
+		if (data->delays[2])
+			msleep(DIV_ROUND_UP(data->delays[2], 1000));
 	}
 #endif