Commit b0c83ae1 authored by Inaky Perez-Gonzalez's avatar Inaky Perez-Gonzalez Committed by Greg Kroah-Hartman

wimax: Makefile, Kconfig and docbook linkage for the stack

This patch provides Makefile and KConfig for the WiMAX stack,
integrating them into the networking stack's Makefile, Kconfig and
doc-book templates.
Signed-off-by: default avatarInaky Perez-Gonzalez <inaky@linux.intel.com>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@suse.de>
parent 617209cc
......@@ -74,6 +74,14 @@
!Enet/sunrpc/rpcb_clnt.c
!Enet/sunrpc/clnt.c
</sect1>
<sect1><title>WiMAX</title>
!Enet/wimax/op-msg.c
!Enet/wimax/op-reset.c
!Enet/wimax/op-rfkill.c
!Enet/wimax/stack.c
!Iinclude/net/wimax.h
!Iinclude/linux/wimax.h
</sect1>
</chapter>
<chapter id="netdev">
......
......@@ -254,6 +254,8 @@ source "net/mac80211/Kconfig"
endif # WIRELESS
source "net/wimax/Kconfig"
source "net/rfkill/Kconfig"
source "net/9p/Kconfig"
......
......@@ -63,3 +63,4 @@ endif
ifeq ($(CONFIG_NET),y)
obj-$(CONFIG_SYSCTL) += sysctl_net.o
endif
obj-$(CONFIG_WIMAX) += wimax/
#
# WiMAX LAN device configuration
#
menuconfig WIMAX
tristate "WiMAX Wireless Broadband support"
help
Select to configure support for devices that provide
wireless broadband connectivity using the WiMAX protocol
(IEEE 802.16).
Please note that most of these devices require signing up
for a service plan with a provider.
The different WiMAX drivers can be enabled in the menu entry
Device Drivers > Network device support > WiMAX Wireless
Broadband devices
If unsure, it is safe to select M (module).
config WIMAX_DEBUG_LEVEL
int "WiMAX debug level"
depends on WIMAX
default 8
help
Select the maximum debug verbosity level to be compiled into
the WiMAX stack code.
By default, debug messages are disabled at runtime and can
be selectively enabled for different parts of the code using
the sysfs debug-levels file.
If set at zero, this will compile out all the debug code.
It is recommended that it is left at 8.
obj-$(CONFIG_WIMAX) += wimax.o
wimax-y := \
id-table.o \
op-msg.o \
op-reset.o \
op-rfkill.o \
stack.o
wimax-$(CONFIG_DEBUG_FS) += debugfs.o
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment