MIPS: BCM63XX: generate WLAN MAC address after registering ethernet devices.

In case the MAC address pool is not big enough to also register a WLAN device
prefer registering the Ethernet devices.

[ralf@linux-mips.org: Fixed formatting as per Sergei's complaint.]
Signed-off-by: Florian Fainelli <florian@openwrt.org>
Cc: linux-mips@linux-mips.org
Patchwork: https://patchwork.linux-mips.org/patch/3013/Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

arch/mips/bcm63xx/boards/board_bcm963xx.c

@@ -791,18 +791,6 @@ void __init board_prom_init(void)
 	}
 
 	bcm_gpio_writel(val, GPIO_MODE_REG);
-
-	/* Generate MAC address for WLAN and
-	 * register our SPROM */
-#ifdef CONFIG_SSB_PCIHOST
-	if (!board_get_mac_address(bcm63xx_sprom.il0mac)) {
-		memcpy(bcm63xx_sprom.et0mac, bcm63xx_sprom.il0mac, ETH_ALEN);
-		memcpy(bcm63xx_sprom.et1mac, bcm63xx_sprom.il0mac, ETH_ALEN);
-		if (ssb_arch_register_fallback_sprom(
-				&bcm63xx_get_fallback_sprom) < 0)
-			printk(KERN_ERR PFX "failed to register fallback SPROM\n");
-	}
-#endif
 }
 
 /*
@@ -886,6 +874,19 @@ int __init board_register_devices(void)
 	if (board.has_dsp)
 		bcm63xx_dsp_register(&board.dsp);
 
+	/* Generate MAC address for WLAN and register our SPROM,
+	 * do this after registering enet devices
+	 */
+#ifdef CONFIG_SSB_PCIHOST
+	if (!board_get_mac_address(bcm63xx_sprom.il0mac)) {
+		memcpy(bcm63xx_sprom.et0mac, bcm63xx_sprom.il0mac, ETH_ALEN);
+		memcpy(bcm63xx_sprom.et1mac, bcm63xx_sprom.il0mac, ETH_ALEN);
+		if (ssb_arch_register_fallback_sprom(
+				&bcm63xx_get_fallback_sprom) < 0)
+			pr_err(PFX "failed to register fallback SPROM\n");
+	}
+#endif
+
 	/* read base address of boot chip select (0) */
 	val = bcm_mpi_readl(MPI_CSBASE_REG(0));
 	val &= MPI_CSBASE_BASE_MASK;