drivers/leds/leds-lp5521.c: check if reset is successful

Make sure that the reset is successful by issuing a dummy read to R
channel current register and check its default value.  On some platforms,
without this dummy read, any further access to {R/G/B}_EXEC will not have
any impact.

[akpm@linux-foundation.org: fix up code comment]
Signed-off-by: srinidhi kasagar <srinidhi.kasagar@stericsson.com>
Tested-by: Naga Radhesh <naga.radheshy@stericsson.com>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Cc: Richard Purdie <richard.purdie@linuxfoundation.org>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

drivers/leds/leds-lp5521.c

@@ -97,6 +97,9 @@
 /* Status */
 #define LP5521_EXT_CLK_USED		0x08
 
+/* default R channel current register value */
+#define LP5521_REG_R_CURR_DEFAULT	0xAF
+
 struct lp5521_engine {
 	int		id;
 	u8		mode;
@@ -643,6 +646,7 @@ static int __devinit lp5521_probe(struct i2c_client *client,
 	struct lp5521_chip		*chip;
 	struct lp5521_platform_data	*pdata;
 	int ret, i, led;
+	u8 buf;
 
 	chip = kzalloc(sizeof(*chip), GFP_KERNEL);
 	if (!chip)
@@ -681,6 +685,20 @@ static int __devinit lp5521_probe(struct i2c_client *client,
 				     * Exact value is not available. 10 - 20ms
 				     * appears to be enough for reset.
 				     */
+
+	/*
+	 * Make sure that the chip is reset by reading back the r channel
+	 * current reg. This is dummy read is required on some platforms -
+	 * otherwise further access to the R G B channels in the
+	 * LP5521_REG_ENABLE register will not have any effect - strange!
+	 */
+	lp5521_read(client, LP5521_REG_R_CURRENT, &buf);
+	if (buf != LP5521_REG_R_CURR_DEFAULT) {
+		dev_err(&client->dev, "error in reseting chip\n");
+		goto fail2;
+	}
+	usleep_range(10000, 20000);
+
 	ret = lp5521_detect(client);
 
 	if (ret) {