USB: omninet: clean up protocol description

Clean up and fix typos in protocol comment.
Signed-off-by: Johan Hovold <jhovold@gmail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/usb/serial/omninet.c

@@ -74,29 +74,28 @@ static struct usb_serial_driver * const serial_drivers[] = {
 };
 
 
-/* The protocol.
+/*
+ * The protocol.
  *
  * The omni.net always exchange 64 bytes of data with the host. The first
- * four bytes are the control header, you can see it in the above structure.
+ * four bytes are the control header.
  *
  * oh_seq is a sequence number. Don't know if/how it's used.
  * oh_len is the length of the data bytes in the packet.
  * oh_xxx Bit-mapped, related to handshaking and status info.
- *	I normally set it to 0x03 in trasmitted frames.
+ *	I normally set it to 0x03 in transmitted frames.
  *	7: Active when the TA is in a CONNECTed state.
  *	6: unknown
  *	5: handshaking, unknown
  *	4: handshaking, unknown
  *	3: unknown, usually 0
  *	2: unknown, usually 0
- *	1: handshaking, unknown, usually set to 1 in trasmitted frames
- *	0: handshaking, unknown, usually set to 1 in trasmitted frames
+ *	1: handshaking, unknown, usually set to 1 in transmitted frames
+ *	0: handshaking, unknown, usually set to 1 in transmitted frames
  * oh_pad Probably a pad byte.
  *
  * After the header you will find data bytes if oh_len was greater than zero.
- *
  */
-
 struct omninet_header {
 	__u8	oh_seq;
 	__u8	oh_len;