xhci: Increase reset timeout for Renesas 720201 host.

commit 22ceac19 upstream.

The NEC/Renesas 720201 xHCI host controller does not complete its reset
within 250 milliseconds.  In fact, it takes about 9 seconds to reset the
host controller, and 1 second for the host to be ready for doorbell
rings.  Extend the reset and CNR polling timeout to 10 seconds each.

This patch should be backported to kernels as old as 2.6.31, that
contain the commit 66d4eadd "USB: xhci:
BIOS handoff and HW initialization."
Signed-off-by: Sarah Sharp <sarah.a.sharp@linux.intel.com>
Reported-by: Edwin Klein Mentink <e.kleinmentink@zonnet.nl>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/usb/host/xhci.c

@@ -163,7 +163,7 @@ int xhci_reset(struct xhci_hcd *xhci)
 	xhci_writel(xhci, command, &xhci->op_regs->command);
 
 	ret = handshake(xhci, &xhci->op_regs->command,
-			CMD_RESET, 0, 250 * 1000);
+			CMD_RESET, 0, 10 * 1000 * 1000);
 	if (ret)
 		return ret;
 
@@ -172,7 +172,8 @@ int xhci_reset(struct xhci_hcd *xhci)
 	 * xHCI cannot write to any doorbells or operational registers other
 	 * than status until the "Controller Not Ready" flag is cleared.
 	 */
-	return handshake(xhci, &xhci->op_regs->status, STS_CNR, 0, 250 * 1000);
+	return handshake(xhci, &xhci->op_regs->status,
+			 STS_CNR, 0, 10 * 1000 * 1000);
 }
 
 /*