Commit b5f5fe80 authored by Magnus Damm's avatar Magnus Damm Committed by Paul Mundt

sh: remove dead LED code for migo-r and ms7724se

CONFIG_PM is always set on SH-Mobile these days so
get rid of the unused LED setup code.
Signed-off-by: default avatarMagnus Damm <damm@opensource.se>
Signed-off-by: default avatarPaul Mundt <lethal@linux-sh.org>
parent 6b3b5575
......@@ -496,23 +496,11 @@ static int __init migor_devices_setup(void)
&migor_sdram_enter_end,
&migor_sdram_leave_start,
&migor_sdram_leave_end);
#ifdef CONFIG_PM
/* Let D11 LED show STATUS0 */
gpio_request(GPIO_FN_STATUS0, NULL);
/* Lit D12 LED show PDSTATUS */
gpio_request(GPIO_FN_PDSTATUS, NULL);
#else
/* Lit D11 LED */
gpio_request(GPIO_PTJ7, NULL);
gpio_direction_output(GPIO_PTJ7, 1);
gpio_export(GPIO_PTJ7, 0);
/* Lit D12 LED */
gpio_request(GPIO_PTJ5, NULL);
gpio_direction_output(GPIO_PTJ5, 1);
gpio_export(GPIO_PTJ5, 0);
#endif
/* SMC91C111 - Enable IRQ0, Setup CS4 for 16-bit fast access */
gpio_request(GPIO_FN_IRQ0, NULL);
......
......@@ -629,7 +629,6 @@ static int __init devices_setup(void)
/* turn on USB clocks, use external clock */
__raw_writew((__raw_readw(PORT_MSELCRB) & ~0xc000) | 0x8000, PORT_MSELCRB);
#ifdef CONFIG_PM
/* Let LED9 show STATUS2 */
gpio_request(GPIO_FN_STATUS2, NULL);
......@@ -638,22 +637,6 @@ static int __init devices_setup(void)
/* Lit LED11 show PDSTATUS */
gpio_request(GPIO_FN_PDSTATUS, NULL);
#else
/* Lit LED9 */
gpio_request(GPIO_PTJ6, NULL);
gpio_direction_output(GPIO_PTJ6, 1);
gpio_export(GPIO_PTJ6, 0);
/* Lit LED10 */
gpio_request(GPIO_PTJ5, NULL);
gpio_direction_output(GPIO_PTJ5, 1);
gpio_export(GPIO_PTJ5, 0);
/* Lit LED11 */
gpio_request(GPIO_PTJ7, NULL);
gpio_direction_output(GPIO_PTJ7, 1);
gpio_export(GPIO_PTJ7, 0);
#endif
/* enable USB0 port */
__raw_writew(0x0600, 0xa40501d4);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment