Commit b6c9f105 authored by Manuel Lauss's avatar Manuel Lauss Committed by Ralf Baechle

MIPS: Alchemy: xxs1500: use linux gpio api.

Replace a few GPIO register accesses in the board init code with calls to
the gpio api.
Signed-off-by: default avatarManuel Lauss <manuel.lauss@gmail.com>
Signed-off-by: default avatarRalf Baechle <ralf@linux-mips.org>
parent bb706b28
......@@ -23,6 +23,7 @@
* 675 Mass Ave, Cambridge, MA 02139, USA.
*/
#include <linux/gpio.h>
#include <linux/init.h>
#include <linux/delay.h>
......@@ -50,6 +51,9 @@ void __init board_setup(void)
}
#endif
alchemy_gpio1_input_enable();
alchemy_gpio2_enable();
/* Set multiple use pins (UART3/GPIO) to UART (it's used as UART too) */
pin_func = au_readl(SYS_PINFUNC) & ~SYS_PF_UR3;
pin_func |= SYS_PF_UR3;
......@@ -65,20 +69,19 @@ void __init board_setup(void)
au_writel(0x01, UART3_ADDR + UART_MCR); /* UART_MCR_DTR is 0x01??? */
#ifdef CONFIG_PCMCIA_XXS1500
/* Setup PCMCIA signals */
au_writel(0, SYS_PININPUTEN);
/* GPIO 0, 1, and 4 are inputs */
au_writel(1 | (1 << 1) | (1 << 4), SYS_TRIOUTCLR);
alchemy_gpio_direction_input(0);
alchemy_gpio_direction_input(1);
alchemy_gpio_direction_input(4);
/* Enable GPIO2 if not already enabled */
au_writel(1, GPIO2_ENABLE);
/* GPIO2 208/9/10/11 are inputs */
au_writel((1 << 8) | (1 << 9) | (1 << 10) | (1 << 11), GPIO2_DIR);
alchemy_gpio_direction_input(208);
alchemy_gpio_direction_input(209);
alchemy_gpio_direction_input(210);
alchemy_gpio_direction_input(211);
/* Turn off power */
au_writel((au_readl(GPIO2_PINSTATE) & ~(1 << 14)) | (1 << 30),
GPIO2_OUTPUT);
alchemy_gpio_direction_output(214, 0);
#endif
#ifdef CONFIG_PCI
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment