dt-bindings: mfd: Correct interrupt flags in examples

GPIO_ACTIVE_x flags are not correct in the context of interrupt flags.
These are simple defines so they could be used in DTS but they will not
have the same meaning:
1. GPIO_ACTIVE_HIGH = 0 = IRQ_TYPE_NONE
2. GPIO_ACTIVE_LOW  = 1 = IRQ_TYPE_EDGE_RISING

Correct the interrupt flags, assuming the author of the code wanted same
logical behavior behind the name "ACTIVE_xxx", this is:
  ACTIVE_LOW => IRQ_TYPE_LEVEL_LOW
Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>
Acked-by: Matti Vaittinen <matti.vaittinen@fi.rohmeurope.com> # for BD70528
Acked-by: Tim Harvey <tharvey@gateworks.com> # for gateworks-gsc.yaml
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Lee Jones <lee.jones@linaro.org>

Documentation/devicetree/bindings/mfd/act8945a.txt

@@ -71,7 +71,7 @@ Example:
 			pinctrl-names = "default";
 			pinctrl-0 = <&pinctrl_charger_chglev &pinctrl_charger_lbo &pinctrl_charger_irq>;
 			interrupt-parent = <&pioA>;
-			interrupts = <45 GPIO_ACTIVE_LOW>;
+			interrupts = <45 IRQ_TYPE_LEVEL_LOW>;
 
 			active-semi,chglev-gpios = <&pioA 12 GPIO_ACTIVE_HIGH>;
 			active-semi,lbo-gpios = <&pioA 72 GPIO_ACTIVE_LOW>;

Documentation/devicetree/bindings/mfd/gateworks-gsc.yaml

@@ -147,6 +147,7 @@ required:
 examples:
   - |
     #include <dt-bindings/gpio/gpio.h>
+    #include <dt-bindings/interrupt-controller/irq.h>
     i2c {
         #address-cells = <1>;
         #size-cells = <0>;
@@ -155,7 +156,7 @@ examples:
             compatible = "gw,gsc";
             reg = <0x20>;
             interrupt-parent = <&gpio1>;
-            interrupts = <4 GPIO_ACTIVE_LOW>;
+            interrupts = <4 IRQ_TYPE_LEVEL_LOW>;
             interrupt-controller;
             #interrupt-cells = <1>;
             #address-cells = <1>;

Documentation/devicetree/bindings/mfd/rohm,bd70528-pmic.txt

@@ -39,7 +39,7 @@ pmic: pmic@4b {
 	compatible = "rohm,bd70528";
 	reg = <0x4b>;
 	interrupt-parent = <&gpio1>;
-	interrupts = <29 GPIO_ACTIVE_LOW>;
+	interrupts = <29 IRQ_TYPE_LEVEL_LOW>;
 	clocks = <&osc 0>;
 	#clock-cells = <0>;
 	clock-output-names = "bd70528-32k-out";