Commit b899e698 authored by Yaniv Rosner's avatar Yaniv Rosner Committed by David S. Miller

bnx2x: Fix 578xx-KR 1G link

Fix a problem where 578xx-KR is unable to get link when connected to 1G link
partner. Two fixes were required:
One was to force CL37 sync_status low to prevent Warpcore from getting stuck in
CL73 parallel detect loop while link partner is sending.
Second fix was to enable auto-detect mode, thus allowing the Warpcore to select
the higher speed protocol between 10G-KR (over CL73), or go down to 1G over CL73
when there's indication for it.
Signed-off-by: default avatarYaniv Rosner <yanivr@broadcom.com>
Signed-off-by: default avatarAriel Elior <ariele@broadcom.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 8d88bbff
......@@ -3865,6 +3865,19 @@ static void bnx2x_warpcore_enable_AN_KR(struct bnx2x_phy *phy,
bnx2x_warpcore_enable_AN_KR2(phy, params, vars);
} else {
/* Enable Auto-Detect to support 1G over CL37 as well */
bnx2x_cl45_write(bp, phy, MDIO_WC_DEVAD,
MDIO_WC_REG_SERDESDIGITAL_CONTROL1000X1, 0x10);
/* Force cl48 sync_status LOW to avoid getting stuck in CL73
* parallel-detect loop when CL73 and CL37 are enabled.
*/
CL22_WR_OVER_CL45(bp, phy, MDIO_REG_BANK_AER_BLOCK,
MDIO_AER_BLOCK_AER_REG, 0);
bnx2x_cl45_write(bp, phy, MDIO_WC_DEVAD,
MDIO_WC_REG_RXB_ANA_RX_CONTROL_PCI, 0x0800);
bnx2x_set_aer_mmd(params, phy);
bnx2x_disable_kr2(params, vars, phy);
}
......
......@@ -7179,6 +7179,7 @@ Theotherbitsarereservedandshouldbezero*/
#define MDIO_WC_REG_RX1_PCI_CTRL 0x80ca
#define MDIO_WC_REG_RX2_PCI_CTRL 0x80da
#define MDIO_WC_REG_RX3_PCI_CTRL 0x80ea
#define MDIO_WC_REG_RXB_ANA_RX_CONTROL_PCI 0x80fa
#define MDIO_WC_REG_XGXSBLK2_UNICORE_MODE_10G 0x8104
#define MDIO_WC_REG_XGXS_STATUS3 0x8129
#define MDIO_WC_REG_PAR_DET_10G_STATUS 0x8130
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment