Commit b8f15b7e authored by Paul Walmsley's avatar Paul Walmsley

ARM: OMAP2+: CM: increase the module disable timeout

Increase the timeout for disabling an IP block to five milliseconds.
This is to handle the usb_host_fs idle latency, which takes almost
four milliseconds after a host controller reset.

This is the second of two patches needed to resolve the following
boot warning:

omap_hwmod: usb_host_fs: _wait_target_disable failed

Thanks to Sergei Shtylyov <sshtylyov@mvista.com> for finding
an unrelated hunk in a previous version of this patch.
Signed-off-by: default avatarPaul Walmsley <paul@pwsan.com>
Cc: Sergei Shtylyov <sshtylyov@mvista.com>
Cc: Tero Kristo <t-kristo@ti.com>
parent 9a47d32d
...@@ -22,4 +22,15 @@ ...@@ -22,4 +22,15 @@
*/ */
#define MAX_MODULE_READY_TIME 2000 #define MAX_MODULE_READY_TIME 2000
/*
* MAX_MODULE_DISABLE_TIME: max duration in microseconds to wait for
* the PRCM to request that a module enter the inactive state in the
* case of OMAP2 & 3. In the case of OMAP4 this is the max duration
* in microseconds for the module to reach the inactive state from
* a functional state.
* XXX FSUSB on OMAP4430 takes ~4ms to idle after reset during
* kernel init.
*/
#define MAX_MODULE_DISABLE_TIME 5000
#endif #endif
...@@ -313,9 +313,9 @@ int omap4_cminst_wait_module_idle(u8 part, u16 inst, s16 cdoffs, u16 clkctrl_off ...@@ -313,9 +313,9 @@ int omap4_cminst_wait_module_idle(u8 part, u16 inst, s16 cdoffs, u16 clkctrl_off
omap_test_timeout((_clkctrl_idlest(part, inst, cdoffs, clkctrl_offs) == omap_test_timeout((_clkctrl_idlest(part, inst, cdoffs, clkctrl_offs) ==
CLKCTRL_IDLEST_DISABLED), CLKCTRL_IDLEST_DISABLED),
MAX_MODULE_READY_TIME, i); MAX_MODULE_DISABLE_TIME, i);
return (i < MAX_MODULE_READY_TIME) ? 0 : -EBUSY; return (i < MAX_MODULE_DISABLE_TIME) ? 0 : -EBUSY;
} }
/** /**
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment