Commit ba64792f authored by Faiz Abbas's avatar Faiz Abbas Committed by Ulf Hansson

ARM: OMAP2+: hsmmc.c: Remove dead code

Most platforms using OMAP hsmmc driver have switched to device tree
for passing platform data to omap_hsmmc.c driver.

The hsmmc.c file in mach-omap2 exists only to support pandora board
which uses wl1251 driver in legacy platform data mode.

Hence, remove the dead code not used by the pandora board.
Signed-off-by: default avatarFaiz Abbas <faiz_abbas@ti.com>
Acked-by: default avatarTony Lindgren <tony@atomide.com>
Signed-off-by: default avatarUlf Hansson <ulf.hansson@linaro.org>
parent 26cb2be4
......@@ -32,120 +32,6 @@ static u16 control_devconf1_offset;
#define HSMMC_NAME_LEN 9
static void omap_hsmmc1_before_set_reg(struct device *dev,
int power_on, int vdd)
{
u32 reg, prog_io;
struct omap_hsmmc_platform_data *mmc = dev->platform_data;
if (mmc->remux)
mmc->remux(dev, power_on);
/*
* Assume we power both OMAP VMMC1 (for CMD, CLK, DAT0..3) and the
* card with Vcc regulator (from twl4030 or whatever). OMAP has both
* 1.8V and 3.0V modes, controlled by the PBIAS register.
*
* In 8-bit modes, OMAP VMMC1A (for DAT4..7) needs a supply, which
* is most naturally TWL VSIM; those pins also use PBIAS.
*
* FIXME handle VMMC1A as needed ...
*/
if (power_on) {
if (cpu_is_omap2430()) {
reg = omap_ctrl_readl(OMAP243X_CONTROL_DEVCONF1);
if ((1 << vdd) >= MMC_VDD_30_31)
reg |= OMAP243X_MMC1_ACTIVE_OVERWRITE;
else
reg &= ~OMAP243X_MMC1_ACTIVE_OVERWRITE;
omap_ctrl_writel(reg, OMAP243X_CONTROL_DEVCONF1);
}
if (mmc->internal_clock) {
reg = omap_ctrl_readl(OMAP2_CONTROL_DEVCONF0);
reg |= OMAP2_MMCSDIO1ADPCLKISEL;
omap_ctrl_writel(reg, OMAP2_CONTROL_DEVCONF0);
}
reg = omap_ctrl_readl(control_pbias_offset);
if (cpu_is_omap3630()) {
/* Set MMC I/O to 52MHz */
prog_io = omap_ctrl_readl(OMAP343X_CONTROL_PROG_IO1);
prog_io |= OMAP3630_PRG_SDMMC1_SPEEDCTRL;
omap_ctrl_writel(prog_io, OMAP343X_CONTROL_PROG_IO1);
} else {
reg |= OMAP2_PBIASSPEEDCTRL0;
}
reg &= ~OMAP2_PBIASLITEPWRDNZ0;
omap_ctrl_writel(reg, control_pbias_offset);
} else {
reg = omap_ctrl_readl(control_pbias_offset);
reg &= ~OMAP2_PBIASLITEPWRDNZ0;
omap_ctrl_writel(reg, control_pbias_offset);
}
}
static void omap_hsmmc1_after_set_reg(struct device *dev, int power_on, int vdd)
{
u32 reg;
/* 100ms delay required for PBIAS configuration */
msleep(100);
if (power_on) {
reg = omap_ctrl_readl(control_pbias_offset);
reg |= (OMAP2_PBIASLITEPWRDNZ0 | OMAP2_PBIASSPEEDCTRL0);
if ((1 << vdd) <= MMC_VDD_165_195)
reg &= ~OMAP2_PBIASLITEVMODE0;
else
reg |= OMAP2_PBIASLITEVMODE0;
omap_ctrl_writel(reg, control_pbias_offset);
} else {
reg = omap_ctrl_readl(control_pbias_offset);
reg |= (OMAP2_PBIASSPEEDCTRL0 | OMAP2_PBIASLITEPWRDNZ0 |
OMAP2_PBIASLITEVMODE0);
omap_ctrl_writel(reg, control_pbias_offset);
}
}
static void hsmmc2_select_input_clk_src(struct omap_hsmmc_platform_data *mmc)
{
u32 reg;
reg = omap_ctrl_readl(control_devconf1_offset);
if (mmc->internal_clock)
reg |= OMAP2_MMCSDIO2ADPCLKISEL;
else
reg &= ~OMAP2_MMCSDIO2ADPCLKISEL;
omap_ctrl_writel(reg, control_devconf1_offset);
}
static void hsmmc2_before_set_reg(struct device *dev, int power_on, int vdd)
{
struct omap_hsmmc_platform_data *mmc = dev->platform_data;
if (mmc->remux)
mmc->remux(dev, power_on);
if (power_on)
hsmmc2_select_input_clk_src(mmc);
}
static int am35x_hsmmc2_set_power(struct device *dev, int power_on, int vdd)
{
struct omap_hsmmc_platform_data *mmc = dev->platform_data;
if (power_on)
hsmmc2_select_input_clk_src(mmc);
return 0;
}
static int nop_mmc_set_power(struct device *dev, int power_on, int vdd)
{
return 0;
}
static int __init omap_hsmmc_pdata_init(struct omap2_hsmmc_info *c,
struct omap_hsmmc_platform_data *mmc)
{
......@@ -157,101 +43,11 @@ static int __init omap_hsmmc_pdata_init(struct omap2_hsmmc_info *c,
return -ENOMEM;
}
if (c->name)
strncpy(hc_name, c->name, HSMMC_NAME_LEN);
else
snprintf(hc_name, (HSMMC_NAME_LEN + 1), "mmc%islot%i",
c->mmc, 1);
snprintf(hc_name, (HSMMC_NAME_LEN + 1), "mmc%islot%i", c->mmc, 1);
mmc->name = hc_name;
mmc->caps = c->caps;
mmc->internal_clock = !c->ext_clock;
mmc->reg_offset = 0;
if (c->cover_only) {
/* detect if mobile phone cover removed */
mmc->gpio_cd = -EINVAL;
mmc->gpio_cod = c->gpio_cd;
} else {
/* card detect pin on the mmc socket itself */
mmc->gpio_cd = c->gpio_cd;
mmc->gpio_cod = -EINVAL;
}
mmc->gpio_wp = c->gpio_wp;
mmc->remux = c->remux;
mmc->init_card = c->init_card;
if (c->nonremovable)
mmc->nonremovable = 1;
/*
* NOTE: MMC slots should have a Vcc regulator set up.
* This may be from a TWL4030-family chip, another
* controllable regulator, or a fixed supply.
*
* temporary HACK: ocr_mask instead of fixed supply
*/
if (soc_is_am35xx())
mmc->ocr_mask = MMC_VDD_165_195 |
MMC_VDD_26_27 |
MMC_VDD_27_28 |
MMC_VDD_29_30 |
MMC_VDD_30_31 |
MMC_VDD_31_32;
else
mmc->ocr_mask = c->ocr_mask;
if (!soc_is_am35xx())
mmc->features |= HSMMC_HAS_PBIAS;
switch (c->mmc) {
case 1:
if (mmc->features & HSMMC_HAS_PBIAS) {
/* on-chip level shifting via PBIAS0/PBIAS1 */
mmc->before_set_reg =
omap_hsmmc1_before_set_reg;
mmc->after_set_reg =
omap_hsmmc1_after_set_reg;
}
if (soc_is_am35xx())
mmc->set_power = nop_mmc_set_power;
/* OMAP3630 HSMMC1 supports only 4-bit */
if (cpu_is_omap3630() &&
(c->caps & MMC_CAP_8_BIT_DATA)) {
c->caps &= ~MMC_CAP_8_BIT_DATA;
c->caps |= MMC_CAP_4_BIT_DATA;
mmc->caps = c->caps;
}
break;
case 2:
if (soc_is_am35xx())
mmc->set_power = am35x_hsmmc2_set_power;
if (c->ext_clock)
c->transceiver = 1;
if (c->transceiver && (c->caps & MMC_CAP_8_BIT_DATA)) {
c->caps &= ~MMC_CAP_8_BIT_DATA;
c->caps |= MMC_CAP_4_BIT_DATA;
}
if (mmc->features & HSMMC_HAS_PBIAS) {
/* off-chip level shifting, or none */
mmc->before_set_reg = hsmmc2_before_set_reg;
mmc->after_set_reg = NULL;
}
break;
case 3:
case 4:
case 5:
mmc->before_set_reg = NULL;
mmc->after_set_reg = NULL;
break;
default:
pr_err("MMC%d configuration not supported!\n", c->mmc);
kfree(hc_name);
return -ENODEV;
}
return 0;
}
......@@ -260,7 +56,6 @@ static int omap_hsmmc_done;
void omap_hsmmc_late_init(struct omap2_hsmmc_info *c)
{
struct platform_device *pdev;
struct omap_hsmmc_platform_data *mmc_pdata;
int res;
if (omap_hsmmc_done != 1)
......@@ -269,32 +64,12 @@ void omap_hsmmc_late_init(struct omap2_hsmmc_info *c)
omap_hsmmc_done++;
for (; c->mmc; c++) {
if (!c->deferred)
continue;
pdev = c->pdev;
if (!pdev)
continue;
mmc_pdata = pdev->dev.platform_data;
if (!mmc_pdata)
continue;
if (c->cover_only) {
/* detect if mobile phone cover removed */
mmc_pdata->gpio_cd = -EINVAL;
mmc_pdata->gpio_cod = c->gpio_cd;
} else {
/* card detect pin on the mmc socket itself */
mmc_pdata->gpio_cd = c->gpio_cd;
mmc_pdata->gpio_cod = -EINVAL;
}
mmc_pdata->gpio_wp = c->gpio_wp;
res = omap_device_register(pdev);
if (res)
pr_err("Could not late init MMC %s\n",
c->name);
pr_err("Could not late init MMC\n");
}
}
......@@ -336,13 +111,6 @@ static void __init omap_hsmmc_init_one(struct omap2_hsmmc_info *hsmmcinfo,
if (oh->dev_attr != NULL) {
mmc_dev_attr = oh->dev_attr;
mmc_data->controller_flags = mmc_dev_attr->flags;
/*
* erratum 2.1.1.128 doesn't apply if board has
* a transceiver is attached
*/
if (hsmmcinfo->transceiver)
mmc_data->controller_flags &=
~OMAP_HSMMC_BROKEN_MULTIBLOCK_READ;
}
pdev = platform_device_alloc(name, ctrl_nr - 1);
......@@ -367,9 +135,6 @@ static void __init omap_hsmmc_init_one(struct omap2_hsmmc_info *hsmmcinfo,
hsmmcinfo->pdev = pdev;
if (hsmmcinfo->deferred)
goto free_mmc;
res = omap_device_register(pdev);
if (res) {
pr_err("Could not register od for %s\n", name);
......
......@@ -12,18 +12,9 @@ struct omap2_hsmmc_info {
u8 mmc; /* controller 1/2/3 */
u32 caps; /* 4/8 wires and any additional host
* capabilities OR'd (ref. linux/mmc/host.h) */
bool transceiver; /* MMC-2 option */
bool ext_clock; /* use external pin for input clock */
bool cover_only; /* No card detect - just cover switch */
bool nonremovable; /* Nonremovable e.g. eMMC */
bool deferred; /* mmc needs a deferred probe */
int gpio_cd; /* or -EINVAL */
int gpio_wp; /* or -EINVAL */
char *name; /* or NULL for default */
struct platform_device *pdev; /* mmc controller instance */
int ocr_mask; /* temporary HACK */
/* Remux (pad configuration) when powering on/off */
void (*remux)(struct device *dev, int power_on);
/* init some special card */
void (*init_card)(struct mmc_card *card);
};
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment